replace the resistor in the heater box that controls the speeds its about $100 from Dodge and takes about 30 sec to replace, open pass side door put head where your feet would go and look up has two screws holding it in and a one plug get the new one first so you know what your looking for
blower resistor is bad
the resistor for the blower motor is busted blower works on high with out it
you have a bare wire touching on your blower motor
when a blower motor only works on high, it is usually due to faulty resistor board. Should be located in the duct near the blower. the purpose of this is so the air blown by the blower keeps the resistors cool.
There is a resistor near the blower that is bad, known cause is high speed only.
If you are saying the Blower Motor only works on high, then your problem is a defective Blower Motor Resistor Pack. Replace it.
Blower switch and connection had a melt down.
A blower motor that only works on high is normally caused by a defective Blower Motor Resistor Pack. DRL, do not have a clue.
Check for a bad blower resistor at blower motor
replace the blower motor switch
Defective Blower Motor Resistor Pack.
bad blower,buy a good one and replace