answersLogoWhite

0


Best Answer

Could be as simple as a good tune up.

User Avatar

Wiki User

7y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What makes car be running smooth then it starts to sputter as if not getting gas i then put gas peddal to the floor and after a few seconds or so the car takes off fast?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the blower motor resistor in a 2008 Nissan sentra?

to the right of the gas peddal


1997 Lincoln Continental abs why does the brake peddal shudder but light is not on?

Where is abs fuse at


How is the bass drum played in a drum kit?

If your meaning the kick peddal on tyhe bass drum then all you have to do is put your foot on the peddal and push down


2009 ml 350 how do you open the hood?

you press the handle beside the brake peddal and there it is done


Why does my car hum when stepping on the gas?

wen stepping on the peddal it show that it sukin alot of fuel Because it doesn't know the words to the song.


Why do the brake lights remain on with the car turned off in 87 Nissan sentra without depressing pedal?

the most common reason is the switch that mounts to the brake peddal is malfunctioning. somecars and truckshave this switch mounted on the mastercylinder. it is difficult to get to and see on some cars and trucks it is under the dash mounted to the brake peddal. some are simple good luck


What problem may it be if your accelerator pedal is flat on the floor?

your acceleration peddal is jammed take it to a local mechanic and it should cost about 500 at the most at the least 100


You are trying to find the labeling for the fuse panel on a 1993 Ford Aerostar?

under the dash to the left of the break peddal around where the hoodlatch cable is on the side almost in the corner should be the fuse box


Bleed brakes Chevy subarban 4x4?

1: have someone pump the brakes while vehicle is running and in park, then hold the peddal down and open the bleeder screw until no air comes out.. this may need to be done a few times.. 2: use a vaccum pump and apply over the bleeder screw, pump the air out and tighten the screw, being careful not to let in any air...


You are trying to find the fuse box in your 1993 ford aerostar please help?

under the dash to the left of the break peddal around where the hoodlatch cable is on the side almost in the corner should be the fuse box


96 SER 2L cold start idles ruff warm running perfect but idle maintains 1300 to 1900 rpm up down what causes this I already changed mass air sensor?

I answered myself after reviewing the whole car. After a new MAFsensor I double checked the vaccum lines and some were cracked. I also change the PCV valve and the car in running like new. This also has helped with the the car jerking once you take the peddal and accelerate it again. I have learned by spending lots of money. So take advise and don't spend as much as I did. GREAT car n fun!


Car stalls when gas pedal is pressed?

Have the same problem. 1999 ford escort. When at dead stop, sometimes, when peddal is pressed to go, car dies. Also , lately, chokes and dies at startup. Seems to be when its hot, .....I live in Hawaii. If you found the solution, radio it to me. Thanks, its been hard to find a similar problem