13mmbolts. gmjim
there is no such thing, the fluid goes into the transmission pan. the very bottom of the trans is a pan, held on with about 20 small bolts..the filter is also in this pan.
It's most likely got a 700R4. One way to find out would be to check into getting a transmission pan gasket, and the parts store will want to know how many bolts are in the pan and what the pan is shaped like. Then, you will know which tranny is in there.
What is the Torque setting on transmission pan bolts 2002 ford ranger?
12ft lbs for transmission pan bolts
Bolts might come loose from the transmission pan while you are driving your 1987 Ford Aerostar because they have not been torqued to specified tightness. They might also come loose because the bolts are not the right size or are worn.
Take a socket set and test each socket until you find the correct size that fits snugly.
You should begin by tightening the transmission and bolts on each corner of the transmission pan. Next, tighten the middle bolts on each side of the transmission pan. Work from the middle to the end, alternating from side to side.
Begin by removing the oil from your 1999 Chevrolet Camaro oil pan. Remove the oil pan retaining bolts. Remove the oil pan gasket and clean the surface. Reverse the process to install the new oil pan.
20
You will need to drain the oil from your 1988 Chevrolet Camaro oil pan. Remove the oil pan retaining bolts. Remove the oil pump retaining bolts. Reverse the process to install the new oil pump.
16 bolts on the trany oil pan is a 700r and 12 bolts on pan is a 400r
There is a plug on the lower part of the transmission pan or on older models by removing bolts that holds pan on transmission one at a time, let oil dain and then remove pan completely.