Want this question answered?
U have to use a special "Quick Disconnect" tool. Usually about 5 bucks...
# Open hood # Disconnect negative battery cable # Disconnect the electrical connector from the back of the headlight reflector # Rotate the retaining ring about 1/8 turn counterclockwise and slide it off the base
i have a 99 ford ranger xlt. my code scanner connector is not working,is there a fuse for it
Yes.
The slave cylinder on a 1988 Ranger can not be repaired. The cylinder will have to be replaced, then the system bled.
where is the number 3 cylinder located on a 2.5 ford ranger engine
You need a special tool for the job. The tool is available at most auto parts stores.
I am converting a ford ranger automatic (a4ld) transmission 4wd to a 5 speed manual from a 4 cylinder ford ranger. Will it work. What is needed?
Firing order for 1996 Ranger 4-cylinder engine is 1-3-4-2.
Several factors are involved with the ability to swap these transmissions. Depending on the Ranger year, the bellhousing and clutch systems can be different sizes, as well as the mounts. With the year of the Ranger and the 6 cylinder transmission then you can determine if the switch is possible.
you follow the bottom radiator hose to the thermostat housing and disconnect the electrical connector ( the housing is located at the front of the intake manifold) you loosen the hose clamp and remove the hose then take out the housing bolts and remove the housing and the thermostat is right there make sure you put the new one in the same way the old one came out
theres two bolts that hold it to the fire wall then disconnect the hoses and unclip the rod from the clutch petal then put your new one in in reverse order