Go to : chevroletforum.com - Impala - Sticky : Impala light bulb number/sizing guide...
H11
See sources and related links below for 2007 Chevrolet Impala headlight bulb part numbers.
I would also like an answer for this question.
Pull the blown one out and just buy one identical to it.
See Headlamp Assembly removal, under Section 5: Service and Appearance Care - Bulb replacement, on page 5-53 of your "Owner's Manual"...
how do I replace interior light bulbs in 2002 chevy impala. I removed the cover, but the bulb is cramped in and I can't pull it out.
Removal WARNING: The halogen bulb contains gas under pressure. The bulb may shatter if the glass envelope is scratched or if the bulb is dropped. Handle the bulb only by its base. Avoid touching the glass envelope. NOTE: The headlamp bulb should not be removed from the headlamp until just before a new bulb is installed. Removing the bulb for an extended period of time may effect headlamp bulb performance. Contaminants may enter the headlamp where they can settle on the lens and reflector. Never turn on the headlamp with the bulb removed from the headlamp. # NOTE: Make sure that the headlamp switch and the ignition switch are in the OFF position. Disconnect the headlamp connector. # Remove the headlamp bulb. ## Rotate the headlamp bulb retainer counterclockwise one-eighth turn and remove. ## Remove the headlamp bulb.Installation CAUTION: Bulbs 9004 and 9007 look similar, but are not interchangeable. # Install the headlamp bulb. ## Install the headlamp bulb. ## Rotate the headlamp bulb retainer clockwise one-eighth turn.# Connect the headlamp connector.
Removal WARNING: The halogen bulb contains gas under pressure. The bulb may shatter if the glass envelope is scratched or if the bulb is dropped. Handle the bulb only by its base. Avoid touching the glass envelope. NOTE: The headlamp bulb should not be removed from the headlamp until just before a new bulb is installed. Removing the bulb for an extended period of time may effect headlamp bulb performance. Contaminants may enter the headlamp where they can settle on the lens and reflector. Never turn on the headlamp with the bulb removed from the headlamp. # NOTE: Make sure that the headlamp switch and the ignition switch are in the OFF position. Disconnect the headlamp connector. # Remove the headlamp bulb. ## Rotate the headlamp bulb retainer counterclockwise one-eighth turn and remove. ## Remove the headlamp bulb.Installation CAUTION: Bulbs 9004 and 9007 look similar, but are not interchangeable. # Install the headlamp bulb. ## Install the headlamp bulb. ## Rotate the headlamp bulb retainer clockwise one-eighth turn.# Connect the headlamp connector.
you will probably have to loosen the complete light assembly so you can get you hand in back of the light to change the bulbs, once you can get to them unplug the wires to the bulb and then either pull or twist the bulb out.
If the passenger side headlight on a 2001 Chevy Impala is dim, it may be time to change the bulb, or there is a problem with the wiring on that side.
***CAUTION***The halogen bulb contains gas under pressure. The bulb may shatter if the gas envelope is scratched or if the bulb is dropped. Handle the bulb carefully. Grasp the bulb only by its base. Avoid touching the glass envelope. è The headlamp bulb should not be removed from the headlamp until just before a replacement bulb is installed. Removing the bulb for an extended period of time may affect headlamp bulb performance. Contaminants may enter the headlamp where they can settle on the lens and reflector. Never turn on the headlamps with the bulb removed from the headlamp. Headlights Removal & Installation 1. Raise and support the hood. 2. Raise the headlamp retainers by pushing rearward and pulling up. 3. If equipped, rotate the headlamp bulb protective counterclockwise and remove. 4. Disconnect the headlamp bulb electrical connector. 5. Remove the headlamp assembly. 6. Rotate headlamp bulb retainer counterclockwise and remove. 7. Remove the headlamp bulb by pulling it straight out with a gentle up-and-down rocking motion. ***WARNING*** Do not touch the glass bulb with your fingers. Oil from your fingers can severely shorten the life of the bulb. If necessary, wipe off any dirt or oil from the bulb with rubbing alcohol before completing installation. To Install; 8. Install a new bulb into the headlamp assembly. 9. Install the headlamp bulb retainer and turn it clockwise to engage the retaining tabs. 10. Attach the bulb electrical connector. 11. If equipped, install the headlamp bulb protective cover. 12. Install the headlamp assembly. è Be sure the headlamp assembly is positioned correctly with the alignment pins inserted into the proper holes and onto the ribs of the reinforcement. 13. Engage the retainers by gently pushing down. 14. Turn the lights on and check the bulb operation.
you cannot service panel lights on 2000 impala . you hav to replace the instrument cluster.