it would be the bulb.
If you are saying you have to manually turn the blinker on and off by hand, then the flasher relay is bad. If you are saying you have to hold the turn signal lever in position and it does work and flashes on and off by doing this, then the turn signal lever is broken inside and needs replacing.
there are 2 flasher cans in vehicle.one operates hazards and the other operates the blinkers. change the one that operates the blinkers and your blinkers will work
If both blinker and hazards dont work check your flasher switch.
you need to replace blinker can in your vehicle. the flashers and blinkers have separate flasher cans which is why your flashers still work but not your blinkers
The most probable answer is that you have a bad flasher.
The most likely cause is the turn signal flasher.
Check/change the fuse associated with the blinkers.
I have a 1998 and my flasher is behind the glove box :0) it could be a multi function switch..that operates the blinkers,if so it is in the steering collum..your windsheildwipers,high-low beams,and flasher..
In fact there are none. That's right- there are absolutely no relays for the blinkers. But, there is a flasher, which it sometimes goes bad, and needs to be replaced.
There are separate flasher relays for the hazard lights and turn signals. The flasher relay may be out on your blinkers. The relay for the hazards is behing the fuse box. The relay for the blinkers is behind the lower dash panel to the right of the steering column.
The 2002 Monte Carlo blinker flasher relay switch is located beneath the drivers side dashboard. The blinker flasher relay switch will be above the brake pedal.
chances are your flasher for the blinkers OS bad,the flasher for the hazzards are usually on different circits for emergency situations.