There is one arrow etched in the side of the sprocket that look like this: >
for the left side cam and for the right it looks like this: <
They need to line up with the plastic timing belt cut outs
They are on the camshaft and crankshaft sprockets
The timing marks on a 1993 Geo Metro are located on the on the camshaft and crankshaft sprockets. They must be aligned together to ensure proper initial timing.
When you say 'Timing Marks', there are several places on this engine that has various marks in regards to the Harmonic Balance, Camshaft sprockets, crankshaft, and timing cover. If you are checking the timing, you will use the marks on the timing cover. If you are setting or replacing the timing belt, you will want to use the camshaft sprockets in relation to the crankshaft/harmonic Balance. On this year, the crankshaft key notch should be 12'oclock and the sprockets should have the timing marks 'E' for exhaust and 'I' for intake aligned facing with the 'E' at 3'oclock and the 'I' at 9'oclock. Hope this helps. AJ
A person can time the timing belt on a 1990 Daihatsu Rocky SUV by first aligning the timing marks on the sprockets with the timing chain. The cam shaft and crankshaft are then aligned and the timing belt is slipped over the sprockets.
The chains, and all sprockets have marks on them.The chains, and all sprockets have marks on them.
Line up the timing marks on both camshaft sprockets so that they face each other. And line up the crankshaft pulley mark with the mark on the engine block.
what is the timing marks on the camshaft what is the timing marks on the camshaft
remove two piece oil pan and timing oil pump cover and line up the marks on the chain with the marks on the timing gears crankshaft and camshaft sprockets should show similiar in the book...
the timing marks are on the back of your cam sprockets.
Timing marks are on the sprockets and on the timing belt itself. No other marks are necessary.
You can set the camshaft timing on your automobile by lining up the timing marks. There will be timing marks on the front main pulley and timing marks on the camshaft.
The timing marks on the camshaft sprockets must be directly opposite each other, and aligned with the top edge of the cylinder head. Taken from the Haynes manual Corsa 2000 2003. Hope this helps