Dealer?
Locksmith?
You can get the replacement key at Home Depot, is the car key # 27R
If your key won't turn the lock, make sure the car is in park, and then pull on the steering wheel, one way then the other, while you attempt to turn the key. Should do the trick.
go to Chevrolet dealer
Yes, If you look where the blade meets the key on one side there is a circle, the chip sits behind this plug. the transponder chip is a long glass cylinder inside the key.
You have to take it to a Key reprogrammer, or your local daewoo who will reprogramme it for you.
To find the ignition key code for a 1994 Nissan Sentra SE, check the owner's manual. You can also contact the manufacturer to obtain the code.
No
I had to buy a blank key from a daewoo dealer and then I took it into a hardware store to them to cut it for me. You can get the replacement key at Home Depot, is the car key # 27R I've just been quoted
The "halo" is the lighted ring around where the ignition key goes into the key cylinder for the ignition switch.The "halo" is the lighted ring around where the ignition key goes into the key cylinder for the ignition switch.
The ignition switch. Where the key goes in is the key tumbler.
there is a pin in the backside of the lock cylinder push it in and pry slightly on the bottom of the cylinder and pull it out , it will come out a little stiff because there is a piece of rubber on the side.
You will probably need to visit your local Daewoo dealership for help.