answersLogoWhite

0


Best Answer
Copy

look on the right side of the block There are two, one, a switch that cuts the fuel pump off when the oil pressure drops, it is usally located behind the right hand side of the intake manifold, another that sends the signal to the dash light or gauge whichever you have, that one is located right above the oil filter

User Avatar

Wiki User

โˆ™ 2007-04-30 21:10:36
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: Where can you find the oil sensor unit on a 1995 Chevrolet Caprice Classic?
Write your answer...
Submit

Related Questions

What kind of antifreeze does a 1995 caprice classic use?

what type of antifreeze do i need to use on a 1995 chevrolet caprice


How many gallons of gas does a 1995 Chevrolet caprice classic hold?

23 gallons


What is the top speed for a 4.3 V8 1995 Chevrolet caprice classic?

195mph at least!


Will oil level sensor make your car cut off in a 1995 Chevrolet caprice?

No it will not.


When was the 1995 Chevrolet Caprice Classic launched?

Yes, but I want know when was the 1995 introduced.


Where is the tcc solenoid on a 1995 caprice classic located?

The TCC solenoid on a 1995 Caprice Classic is located in front of the transmission. It is bolted to the bottom of the pump.


What is the location of the computer on a 1995 Caprice Classic?

its located on the bottom of the air filter


What is the fuel rating for a 1995 caprice classic?

Use 87 Octane Regular.


Can a 1996 Chevy caprice classic rear end axle fit on a 1995 Chevy caprice classic?

Yes. 91-96 impala, roadmaster, caprice, and fleetwood rear end are all the same and will fit with no modifications.


Why Key won't turn in a 1995 caprice classic?

how do i get the key tu turn in a 1995 caprice classic, if it stuck? It could be the ignition control switch located on top of the steering column which will need to be replaced or the key cylinder itself.


What would be the problem with your 1995 Chevrolet caprice it just started these you are ddiving down the st and it died but it start back up it did it 3 time today?

sometime my chevrolet caprice 1995 diet when am driving down the road but it start back up what could that be


Is it safe to jump a 1983 Chevy Caprice Classic using a 1995 Ford Aerostar?

yes


What is the specified gap setting for spark plugs on 1995 Chevrolet Caprice Classic automobiles?

Look in your owner's manual or on the placard under the hood. It is listed there. Any parts store can also provide this info, if the placard is missing.


Is there any way to open the trunk of 1995 Chevy caprice classic with keys locked inside of trunk?

No


Will rims from a 1995 caprice classic fit on a fleetwood cadillac years 1993-1996?

Yes


What liter size does a 1995 Chevy Caprice Classic v8 350 have?

350 =5.7 305 = 5.0


What sensor could cause no spark on a 1995 caprice?

No spark would usually be the ignition coil.


What is the easiest way to replace the heater core in a 1995 Chevy Caprice Classic?

pay me $75. lmuller2@ivytech.edu


If a 1995 Caprice Classic has power but will not turn over no clicking or anything but lights and panel lights what is it?

replace the starter


What are some classic dope boy cars?

Chevy Box caprice and the chevy impala are nice 1995-1997


How do you fix a 1995 Chevrolet Caprice Classic when it wont start?

Check the ECM located on the front driver side of the engine block. Cost about $40. It is about 3 inches wide 2 inches high and half inch thick with fine.


Why is your 1995 caprice classic temperature gage showing hot but car is not hot?

Reset it back to zero and see if it works


Where is iat sensor on 1995 Chevrolet 4 wheel drive?

The 1995 model did not use a Idle air tempture sensor ( IAT ) Did not need one for that fuel system.


Where is the mat sensor on a 1995 Chevrolet Tahoe?

That year did not have a Manifold Air Tempture sensor / MAT sensor, no need for it on the Throttle body injection system.


Why does your 1995 Chevrolet caprice misfire after you changed the spark plugs and wires?

you either did not gap the plugs to spec or you put this wires on wrong