Auto Parts and Repairs
Car Fuses and Wiring
Chevy Silverado
Turn Signals and Hazard Lights

Where can you find the wiring diagrams for the fuse block the hazard lights and the horn for a 1981 Chevy Silverado 2 wheel drive 4 barrel 350?

353637

Top Answer
User Avatar
Wiki User
2011-09-14 11:40:21
2011-09-14 11:40:21

go to your local library. They should have a repair manaual in the referece section.

the hazard light fuse, should be in the top left corner of the fuse panel, its an odd shape fuse, it has L shape connectors and its round, sorry I'm not that techincal but i had this truck and i remember my hazards stopped working.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

you probably have a bad fuse. I would check that first if i were you.

User Avatar

It is the fuse for the hazard lights or as they are sometimes called, emergency lights.

User Avatar

If you will notice the hazard lights are not actually flashing, reason being, the hazard flasher relay is defective. Replace it.

User Avatar

if you mean: "why do hazard lights flash when brakes are on", then the answer is because vehicles are equipped with a hazard light relay that supercedes the brake lights. This way, slow moving vehicles can operate under hazard lighting.

User Avatar

the location of the hazard lights is on top of the steering colum.

User Avatar

I have a 1996 Chevy Silverado that I want to turn the driving lights off. How do I do that? Thank you

User Avatar

Hazard lights should be used if a vehicle is pulled over on the side of the road. If a vehicle is going slow when pulling something behind them, hazard lights should also be used.

User Avatar

This bike does not come standard with hazard lights. There are many vendors that sell add on kits that can supply hazard lights. Two of the top web sites are jpcycles.com and denniskirk.com

User Avatar

why do my lights flicker and interior lights flicker

User Avatar

no tail lights no dash lights no radio

User Avatar

Hazard lights are used on a vehicle in an emergency. The driver is supposed to turn the lights on the warn others that their car is experiencing some sort of problem.

User Avatar

Hazard Light versus Dead BatteryNO, IF the battery is truly dead, then the hazard lights will not work.However, if there is some power left in the battery, even though the voltage may be extremely low, then the hazard lights maycontinue to work.

User Avatar

There are a variety of reasons the hazards lights may not work. The flasher module could need replacing. The fuse may be blown. The bulb may be blown. There could even be an electrical malfunction.

User Avatar

The fuse for hazard and signal lights on the Nissan Serena is in the fuse box, bottom row. The flasher fuse for hazard and signal lights is located in the dash just to the left of the radio.

User Avatar

Your car has two flasher relays. One for the turn signal lights and one for the hazard lights. Replace the one for the hazard lights. Any auto parts store can tell you the location and sell you a new one.

User Avatar

yes, but i think more off bright lights not high lights

User Avatar

It's the turn signal indicator-located behind the hazard lights.You have to take it out and replace it.

User Avatar

try replacing all sets of fuses for the hazard and the tail lights.

User Avatar

There aren't any. Hazard lights were not required by law until many years later than 1965.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.