The correct space is .030, find a piece of cardboard or thick paper and lightly glue it on, it will get knocked off when engine starts.
if it is a 2.4 "x" motor, the crankshaft position sensor should be located in the front of the motor "TUCKED" up behind the starter. it is very difficult to find, but it s there.
There are several used car websites like Autotrader.com. You can even find dodge dealers online where you can find your Dodge Dakota.
Locate the front wire on the distributer and follow. it will lead to the crankshaft position sensor.
2006 Dodge Dakota - Where do i find the trailer wiring harness
what type of auto transmission is in a 89 dodge dakota 3.9
You will find the crankshaft position sensor on the passengers side of the engine block, close to the starter.
Someone believes you should, "Take Your coolant tank off and the sensor is located under it. It's fairlly simple to replace once you find it."; You will find a sensor there but not the crankshaft sensor. On a 99 Intrigue with a 3.5L, the crankshaft position sensor is in the engine block just above and behind the starter. get under the car, remove the starter and you should find what you are looking for.
Autozone web page has the Vacuum diagram for the1989 Dodge Dakota.
It's behind one of the camshaft pulleys. Why would a CRANKSHAFT position sensor be behind a CAMSHAFT pulley ??
The Dodge Dakota transmission blueprint is also known as a transmission diagram. The transmission diagrams can be found at most Dodge dealerships.
Look behind the driver wheel at the cranckshaft pulley. There will be a sensor there. It is the pulley with the teeth.
You can find a vacuum line diagram for a 1989 Dodge Dakota by checking the owner's manual. You can also find them at different auto part retail stores.
You can get a 1990 Dodge Dakota fuse diagram in the owner's manual. You can also find it at select auto part stores.
The placement of a crankshaft sensor on a Citreon c4 is on top of the bell housing towards the back of the engine. Since this can be difficult to get to, follow the wires up until you find it.
where crankshaft sensor at?1995 Chevy lumina van v-6 3.1 i couldn't find crankshaft sensor. can u tell me where exactly is that thanks where crankshaft sensor at?1995 Chevy lumina van v-6 3.1 i couldn't find crankshaft sensor. can u tell me where exactly is that thanks
try here http://www.ebooksquad.com/search/97+dodge+dakota+wiring+diagram
The sensor reads from the flywheel so look to the back of the engine or the front of the transmission bellhousing to find it.
Remove the lower timing belt cover and then the sensor should be to the right of the crankshaft pully.
You can buy Dodge Dakota accessories from auto part stores (both local and chain), from mechanics, from the Dodge website and also from Dodge dealerships around the country. You can also find them at various online stores.
You will usually find the crankshaft position sensor at one end or the other of the engine block. Some engines will have it bolted to the block near the front pulley. Others will have it bolted to the bell housing, right over the flywheel. In any case you should find it near one end of the crankshaft or the other.
how can i find where the camshaft sensor on a 1990 mercury marquis
the crankshaft position sensor is located at the underneath side of the engine right at the bottom of the timing chain cover / front of oil pan