i think u mean crank sensor and that would be by the dampener or balancer in the front of engine (near crankshaft)
Where is the camshaft position sensor located on a 1999 ford ranger 4.0 liter engine
On a 3.0 liter v6 the crank sensor is located on the bell housing of the trans.It has a wire coming out at the top right of bell housing. The cam sensor is in the front of the engine near the serpentine belt.
On the 97 s series trucks with the hvs, The camshaft sensor is located inside of the distributor.
The camshaft position sensor, on a Ford 6.0 liter power stroke engine, is located inside of the rear engine cover. The sensor is on the back of the camshaft.
The camshaft position sensor is a part of the distributer. There are 2 electrical plugs going to it, 1 is for the coil,the other is for the Camshaft sensor.
the sensor is underneath the distributor cap
The crankshaft position sensor on a 1998 3.0 dodge caravan is located on the top of the bellhousing towards the firewall.
It is the sensor in the outlet of the catalytic converter.
The camshaft position sensor on a 4.6 liter engine is positioned on the side of the motor on the front of the cylinder head. A 4.6 liter engine has a camshaft position sensor on each cylinder head.
It is located between the camshafts right behind the camshaft pulley's.
it is in the distributor
Would cause intermittent cut out, or dies off/no start. It is located behind the motor mount on the passenger side of the engine. You can remove it with out removing the mount. There is one bolt to loosen and the sensor will pull out.