EGR Systems
GMC Safari
Ford Aerostar XL
Ford E-150 Van

Where is the EGR valve located on a 1993 ford areostar van with a 40 engine?

626364

Top Answer
User Avatar
Wiki User
2005-11-20 10:20:49
2005-11-20 10:20:49

I have a 93 4.0 and it has no EGR valve. My neighbor who is a ford mech. says some don't have EGR's and some have only one O2 sensor.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Need more info. Which valve are you referring too?

User Avatar

On the 4.0 L OHV engine, the EGR valve is located on the driver's side of the engine. how do i repair it

User Avatar

The knock sensor for the 1993 Chevy Cavalier is located in the back of the motor. It can also be located in the engine valve.

User Avatar

As I recall, that engine does not have an EGR valve.

User Avatar

Near the firewall behind the engine, or under the dash near the heater core.

User Avatar

The PCV valve on a 1993 F150 is located in the top of the valve cover. it is a plug in type, and is easily replaceable.

User Avatar

pass.side valve cover at the rear

User Avatar

AnswerIt doesn't have a PCV valve.Actually it does. The PCV valve for a 1993 Nissan Altima is located behind the engine below the intake. Buy a Haynes manual, the PCV is VERY tough to get too but it can be done. You can only get two bolts from the top but have to go from underneath the car to detach the hose.

User Avatar

5.0L-The valve is located on top of the block by the firewall 2.3L-The valve is mounted inline with the breather hose

User Avatar

all you have to do is pull it off. it should be located on the top of your engine. i just changed it in mine,

User Avatar

its the hose coming off of the valve cover that's the egr valve

User Avatar

The PCV valve is located on the back side valve cover. It should be a plug in type and easy to change.

User Avatar

UNDER HOOD, CENTER, UPPER ENGINE AREA, TOP OF ENGINE, MOUNTED IN PASSENGER SIDE OF INTAKE MANIFOLD

User Avatar

I believe it is hidden, near the firewall, just below the transmission dip stick.

User Avatar

The 1993 Ford escort did not come with an EGR valve. It is one of a few year models that do not have one.

User Avatar

located in the top of the drivers side valve cover between the front and mibble coil.

User Avatar

Camshaft Position Sensor is on the back of the valve cover on the right side (if looking directly at the engine from the front of the car).

User Avatar

its a Mazda engine . ( DOHC 4cyl. 16 valve 2.0l ) For the probe 1993

User Avatar

It is located at the back of the engine. Look from the left side of the vehicle down into the space between the passenger compartment and the engine block. Towards the top of the engine block is a small hose, labeled PCV. It's a pain to remove.

User Avatar

If it is an electronic EGR valve it is on the top of the engine on the rear left or drivers side it has three solenoids and a wire harness at the top IF YOU HAVE THE V6 (3.3) ENGINE IT DOES NOT HAVE AN EGR VALVE. IF YOU HAVE THE 2.2 4 CYL YOU HAVE A VACUUM TYPE EGR LOCATED ON THE END OF THE HEAD ABOVE THE TRANS.

User Avatar

The service manual states there is a "fuel cut-off" valve which sends evaporated gas in the fuel tank to the EVAP canister in the engine compartment. The valve is located in the fuel tank. I am not sure if this is what you are referring to.

User Avatar

On a 1993 Buick Regal 3.1L, the PCV valve is located on the intake manifold. It is situated underneath the MAP sensor.

User Avatar

The bleed valve is located on the drivers side of the bell housing.

User Avatar

Back left corner of valve cover on 2.0L engines. it is screwed in.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.