I have both a 94 and 96 GP BOTH HAVE IT. can't go very far without one.
Answerthere is no PVC valve on 3.1l grand prix.Poss.came out with the vavle in 95 or 96. AnswerI have a 93 Pontiac grand prix And my pcv valve is on the Rear valve cover. akiller3Mine is on the front valve cover with 1/2" rubber hose attached to it.
AnswerIt is in the intake manifold. There should be a hose going to the throttle body from it. AnswerWhen you replace it, be very careful. The rubber grommet on mine fell into the intake when I pushed the valve in. It is not easy to remove.I'm not exactly sure who said there was no PCV valve and that it came out in 95. What an idiot. There has been some sort of PCV valve system on vehicle engines for decades. I'm sure someone may know better than I, but I think the last engines made without a PCV valve were the old flat head engines built in the 40s. There is most definitely a valve on your engine. It is on the rear valve cover towards the driver side. It is a little difficult to get to....and to get out....but I assure you it is there.
It is on the top back of the engine; there is a 3/4" rubber hose coming from underneath the air intake plenum/manifold that connects to it. Unless you have very small hands you will need to tilt the engine forward to reach it.
IF ITS A QUAD 4 THE HOUSING IS ON THE RIGHT SIDE OF THE VALVE COVER BY THE POWER STEERING BELT 2 BOLTS.
The camshaft sensor on a 1993 Pontiac Grand Am is located behind the rear bearing cap. It detects the position of the camshaft as it rotates and relays this information to the computer.
how do i replace a water hose in 1993 pontiac grand am
A 1993 Pontiac Grand Am weighs approximately 2,828 lbs. The Pontiac Grand Am stopped production in the year 2005. The car was replaced with the Pontiac G6.
If it is not visible at the door jamb, it is probably located in the latch mechanism
Behind the dashboard just off center.
yes it will pontiacs are interchangable from the years 1993-1996
front of the motor bottom of the block on my 96
As I recall, that engine does not have an EGR valve.
Does a 1993 Grand Am have air bags
Under the dash in front of the drivers' left knee.
The blower rheostat on a 93 Pontiac Grand Am is located inside the engine bay, just to the right of the blower fan housing. It is almost directly behind the trans dipstick. It isn't that hard to replace.