it is a dpfe sensor. it should be located on the right side of the engine towards the back. if you have a new one then just look for it.it is the shape of a rectangle with two lines coming out for vaccuum lines.
DO NOT USE THIS COMPANY http://www.pointaengineering.com/main.sc Because they are a fraudulent company! The sensor they provide does absolutly nothing. I tried it and nothing changed in the way my vehicle ran.
Read more: How_do_you_install_a_flex_fuel_sensor
Radar
Some of the 1992 Rangers had the camshaft position sensor on top of the engine in the same hole where the distributor used to be. Some Ranger engines did not use a camshaft sensor at all.
Drivers side engine block above starter.
It doesn't have a knock sensor on the 4.0 L OHV in a 1993 Ranger ( my 1995 Ford Explorer 4.0 L OHV engine doesn't have a knock sensor either )
Replaced the upstream O2 sensor on a 1999 Ford Ranger 3.0 flexfuel and the check engine light went off and came back on after driving approx. 4 miles. Read code and it showed p0153 just as it did before. Is there a certain amount of time that the vehicle has to be driven before the computer will recognize that the new sensor is OK?
On a Ford Ranger ( V6 engine ) Bank 2 is the drivers side of the engine Sensor 1 would be close to the engine before the exhaust enters the catalytic converter
Which engine do you have?
On a 2002 Ford Ranger : The Mass Air Flow Sensor is between the engine air filter and the engine air intake tube
The 2001 Ford Ranger 4.0 liter V-6 engine map sensor is located on the firewall in the engine compartment. The map sensor will be on the drivers side of the firewall.
On the engine.
I'm not a mechanic / technician but the engine wiring schematic in my Chilton repair manual for the 2.3 in a 1994 Ford Ranger does not show a knock sensor
Where can i find a picture of the engine temp sensor location on a 1998 ford escort zetec engine?