0
Where is the camshaft position sensor and how do you replace it on a 1992 Lincoln Town Car?
Wiki User
∙ 14y ago
On the front of the engine block on the drivers side of the engine. Right below the valve covers.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you replace replace the camshaft position sensor?
In order to replace the camshaft position sensor, you would need to disconnect the electrical plug holding it in. Using a socket, hold down the bolt and remove the camshaft position sensor.
How do you replace the camshaft position sensor on a 1997 Plymouth voyager 3 L?
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
Where is the camshaft position sensor located on a 1999 Oldsmobile Intrigue and how do you replace it?
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue
You had change the crankshaft position sensor on your 1995 Lincoln Continental and still wont start any ideas?
try to replace the camshaft position sensor located under the power steering resivoir .. on 4.6 liter lincoln ...
How to replace camshaft position sensor for vw jetta 1999?
how to remplace position of oxigen sensor
How do you replace a camshaft position sensor on a 2000 Nissan Xterra?
How do u replace the camshaft sensor for a 2000 Nissan xterra 3.3L and where is its locatoin
If you replaced the camshaft position sensor should you replace the crankshaft position?
I changed only the camshaft position sensor on my 2000 Kia Sportage. So I don't think so.
Where is the camshaft position sensor on a 2006 Kia Sorento?
do you need to take off the timing belt to replace a camshaft position sensor on a 2006 kia sorento
Where is the location of camshaft position sensor in a 2000 Lincoln LS V8 3.9?
position cam sensor 3.9 licon ls
Where is camshaft sensor on 2002 Lincoln LS?
Where is camshaft sensor on 2002 Lincoln ls
How do you replace the camshaft position sensor on Nissan Altima?
The camshaft position sensor is located near the thermostat housing. You should replace the crankshaft position sensor as well. This one is much harder to locate....it is on the backside of the engine that is between the firewall and the engine block. Both use the same sensor.
How do you replace the camshaft positioning sensor ml27 cdi?
the camshaft position sensor is on the left side of the engine , at back on the upper side . you have to demont the conector , than unscrew and replace it
