front right of cylinder head
Behind oil filter
The 1995 Oldsmobile Aurora 4.0 liter engine crank sensor is located on the back of the crank. You will need to remove the rear engine cover in order to view the crank sensor.
where is the crank position sensor located on a 2004 hyundai v-6 2.7 engine
Where is the crank position senson located on the car
by the harmonic balancer
The crank position sensor is located by the crank shaft on a ford 350 xl 5.8 liter.
Should be by crank pulley.
I can not find where is located the position of sensor crank of 1999 nissan sentra 2.0 ( in what point is located in the motor)
where is the crank position sensor located on 2003 kia Rio 1.8
The crank position sensor is located on the front of the engine, behind the lower crank pulleys.
The 1999 Chevrolet Alamo crank shaft position sensor is located on the back of the engine. You will need to remove the rear engine cover in order to access the crank position sensor.
The 1997 Chevrolet Malibu crank position sensor is located on the back of the crankshaft. The rear engine cover will need to be removed in order to view the sensor.
trying to replace crank position sensor but i have no ideal where to look it is 1993 infinity G20 could you help me find this sensor
where is the crankshaft angle sensor located on a 1997 cadillac deville.
If your 3.5 engine is the same as that in a 2001 Olds Aurora, go to www.autorepair.about.com and search on "2001 aurora 3.5 crank sensor". One of the hits will be a diagram of where the crank sensor is located (above the starter motor). Note that for this engine, a "relearn" mjust be done after replacing the sensor. There is a link to the procedure for removing/installing the sensor and for doing the "relearn". Hope this helps
Where the crankshaft position sensor on a E430 Mercedes located
the crank shaft position sensor should be behind A/C compressor.
It is located on the distributor under the cap and rotor Crank sensor should be on the front bottom of engine by the crank pulley
the crank position sensor is located in front of the oil filter on the left side of the engine in front.
The crankshaft position sensor is located on the top of the transmission. It is located close to the bell housing.
Where is the crank position sensor hole on a 2003 Blazer
under the ac compressor
behind the harmonic balancer.