THE CRANKSHAFT SENSOR IS ON THE FRONT SIDE OF MOTOR DIRECTLY BEHIND THE STARTER......ITS VERY HARD TO SEE BUT IT CAN BE FELT TO PUT A SOCKET WRENCH ON IT....REMOVE WIRING PLUG BEFORE DOING THIS... IT MUST BE PLUGED IN CORRECTLY FOR THE MOTOR TO RUN AND CAN NOT BE BY PASSED. THERE IS ALSO A CAMSHAFT SENSOR ON THE TOP FRONT SIDE OF MOTOR ....ON THE HEAD
check main pulley area bottom by harmonic balance
did u ever figure it out?
The Camshaft Position Sensor is located behind the Power Steering Pump.
well on the 6 cylinder, it is behind the crankshaft pully, try there.
POSSIBLE CRANKSHAFT POSITION SENSOR.
it is right above the oill filter just to the left
The engine won't start.
The crankshaft sensor is in the front of the engine.Above the starter.You will have to drop the starter.2 15mm bolts.Look up and there it will be.
You will fine it right on side of the starter on the front side of the motor
where is crankshaft position sensor and camshaft position sensor on a 2004 Jetta 2.0 gl
the position off the crankshaft sensor
the O2 Sensor Should be on top of your exhaust manifold