The crank shaft position sensor is located on the lower portion of the timing cover to the left side of the crank pully if facing the engine. You will see a two wire harness that comes down around the a/c compressor that pluggs into the sensor. Remove the wire by squeezing the tab with your fingers and pulling away from the sensor. The sensor is held in by one eight mm bolt. After you remove the bolt twist and pull the sensor until it comes out of the hole. To install, reverse removal procedure.
how to replace the crankshaft position sensor located in a 2003 kia rio
where is the crankshaft position sensor on 2.5 liter vw jetta
Check out the related link for a video on how to replace a crankshaft position on a Ford Focus SE.
The crankshaft position is on top of the transmission bell housing on the drivers side. The sensor can be replaced by unbolting and unhooking the plug.
Yes
1983 doesnt have a crankshaft position sensor. you have an ignition module located on the side of the distributor.
Crank position sensor is located next to the crankshaft. In order to replace it you might have to remove the timing belt. In the most models you just can remove remove the timing belt cover and replace the sensor.
where is crankshaft position sensor and camshaft position sensor on a 2004 Jetta 2.0 gl
the position off the crankshaft sensor
Yes there is a crankshaft sensor
The crankshaft position sensor on the PT Cruiser is on the side of the engine above the oil filter. The sensor is removed with two screws. Unplug the wiring, remove the bolts, then install the new sensor.
where is the crankshaft position sensor on a 2004 maxima