0
http://Honda-tech.com/zerothread?id=1065831 This is slightly close up so it's difficult to see in relation to the engine bay. Also this is a civic not an accord, but they are similar designs most likely. The physical location in on the passenger side of the engine. Either connected to or bolted slightly above the engine block.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you replace spart plug tube seal of Honda Accord LX 1994?
How do you replace spart plug tube seal of Honda accord LX 1994?
Oil leak sealant for 1992 Honda accords?
There are several types of oil leak sealant for a 1992 Honda Accord. A few of the sealants that can be used are Bar Leak's seal repair, Lucas Oil, and Blue Devil oil leak sealant.
Can the rear seal on a 1991 Honda accord be changed with the engine in the car?
yes
You have oil on your spark plug wires where is the oil coming from 93 Honda accord ex?
usually the valve cover gasket and the oil seals on the top of the cover,replace gasket and the also the distributor seal
Oil is leaking from drivers side of engine in a Honda 1998 accord?
If oil is leaking from the riverside of a 1998 Honda Accord the vehicle may be experiencing a front seal leak. The main front seal is located on the crankshaft of the engine.
What would cause a sudden oil leak behind the timing belt cover on a 1992 Honda Accord LX?
A bad seal, worn bearings, or maybe even a bent crankshaft.
How can the drivers side floor get wet on a 2000 Honda accord?
Defective windshield seal? Defective door seal or door not adjusted properly?
How do you change a camshaft seal on a 1992 Honda civic?
very carefully
Do ou have to bleed the brakes on a 1992 Honda Accord that is abs?
If you replace any brake component that breaks the brake fluid seal or you let it get very low of brake fluid, yes, you must bleed the brakes.
Passenger floorboard wet after rain Honda accord?
I would check my passenger door seal, the windshield seal, and also the drainage for the grills in the area in front of the windshield.
Where is the ignition fuse box in 2006 Honda Accord coupe?
The ignition fuse box in a 2006 Honda Accord Coupe is located on the right side of the engine compartment. It is seal inside a water tight box to prevent damage.
What is the recommended torque setting on Honda Accord rear wheel bearing?
The Honda accord rear will bearing should be torqued at 60 pounds. You can ruin the wheel bearing or the wheel seal if you over torque the wheel bearing nut.
