Chevy Tahoe
Acura Integra
Honda Prelude SI

Where is the ecu located and how do you remove it safley Integra rs 93 2 door MT?

252627

Top Answer
User Avatar
Wiki User
2005-09-15 05:58:32
2005-09-15 05:58:32

Im not 100% sure but on most honda's and Acura's it is on the passengers side on the floorboard under the carpet. It will be covered in a thick metal case for obvious reasons. hope this is a help.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The first thing you need to do is remove the screws located by the inside door handle and the arm rest on the door. Then you need to remove the other screw located by the door hinge and then carefully ply the paneling off, starting near the bottom.

User Avatar

No 94-2001 are a different body style and will not fit.

User Avatar

You will need to remove the screws in the door. They are located in the door handle, the door latch and at the very bottom of the panel. Once you remove the three screws pull the panel and it will pop out.

User Avatar

The parking lights on a two-door 1990 Acura Integra hatchback are located in between the headlights and the blinker lights. Replacement requires a size 3652 parking light bulb.

User Avatar

2,560 for the 3-door and 2,606 for the 4-door.

User Avatar

To remove the rear door panel of a Mitsubishi 380, first one must remove the power door/lock switch. Next, remove the door handle bezel followed by the screw that was hidden behind that bezel. Finally, remove the screws located by the armrest handle. The rear door panel is now free to be removed.

User Avatar

Answered my own question. Located under passenger seat, need to look closely for L.E.D. located toward front of seat; do not need to remove seat or platic cover; may need to squeeze carpet down near front of seat.

User Avatar

there are several screws located throughout the door panel. some have little covers hiding them (one is located in the top right-hand corner of the door-the little speaker "tweeter"). Just remove all the screws then pry the door off gently.

User Avatar

The 2006 Nissan door lock relay switch is located inside of the drivers side door. You will need to remove the door panel in order to access the door lock relay switch.

User Avatar

you really need a door panel removal tool to do it properly. Remove the two screws located on under the interior pull handle. These screws uslay have a plastic plug on them to hide the screws. Slowly pull the panel away from the bottom of the door. These panels have plastic retaing clips holding them in. There is a tool that is made to remove these safley but you can remove them with out it by pulling the panel a little at a time working your way in a circle till the panel is off. After panel is romved check plastic clips for damage. Install the reverse from top to bottom pushing plastic retainers in slowly all the way around.

User Avatar

On most vehicles, there will be nuts or bolts inside the door the mirror is located on, but under the door panel. If there is a triangular panel separate from the door panel, they may be under this. Otherwise, you will have to remove the door panel to access them.

User Avatar

The door is located behind the glove compartment. Remove the compartment and the ashtray. You will see a small white square box with an electrical wire connection. Its located there

User Avatar

To remove the rear door panel in your Chevy HHR, you will need to remove the two screws located inside of the door pull cup, and there's also one in the middle of the inside door handle. On the outer edge of the door there's also a pin the holds the panel in place, you will need to remove that. Then use a door panel removal tool to pry the door panel off of the HHR rear door. An instructional video has also been enclosed below that shows this entire process and where everything's located. Hope this helps, 1ATony

User Avatar

Remove drivers axle and halfshaft and lower alt braket. take alt out bottom. Or remove brake master cyl. and sqease and pry it out not fun. Dont forget to disconnect battery!!!!!!!!!!

User Avatar

they are located on the door latches one on each side when you remove the hatch cover panel you can get to them easy.

User Avatar

The question you ask is too involved for a proper answer. You may want to go to a car parts store, or book store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library. 1. Remove the cover around the door handle, by opening the door handle, and gently prying it loose with a small screwdriver. 2. Remove the cover located in the armrest by using a small screwdriver. Remove the two screws located there. 3. Remove the light located near the door opening, by gently prying with a small screwdriver. Remove the one screw located there. 4. Remove the plastic pin located in the defogger air duct opening by grasping with needle nose pliers or by prying with a small screwdriver. 5. The entire door panel can then be lifted up and off the door.

User Avatar

To remove the sliding door panel on a Dodge Grand Caravan begin by removing the top plastic panel. Then remove the bottom piece after unscrewing a few screws located on the bottom half of the vans door panel.

User Avatar

The 1993 Jeep Grand Cherokee door lock relay switch is located inside of the drivers side door. You will need to remove the door panel in order to access the door lock relay switch.

User Avatar

The air mix door electric motor is located drivers side. must remove drivers lower instrument panel. door motor is located to the right side on the airbox assembly

User Avatar

the rear speakers are located in the back doors. you have to remove the door panels to get at them.

User Avatar

Remove the inside door panel of your 1987 Chevy. Remove the linkage from the door handle. Remove the door handle retaining bolts. The door handle will come off.

User Avatar

Remove the inside door panel. Remove the door handle linkage. Remove the door handle retaining bolts. The front door handle will come off.

User Avatar

Usually located behind the driver's door panel. Remove inside door panel for access

User Avatar

Remove the 1992 Dodge Dakota inside door panel. The door handle mechanism will be visible. Remove the door handle linkage. Remove the door handle retaining bolts.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.