IAT sensor (intake air temperature) or more commonly known as the MAT (manifold air temperature) sensor is located on either the air intake snorkel or the manifold
Connected to the air intake.
Answerthe intake air temp sensor is located in the air duck.probably right after the air filter box.
It should be located on the air intake hose before the Mass Air Flow Sensor. Hope this helps.RR Of The Engine Compartment
Its in the air cleaner lid towards the rear.
If you look on the hose going from the air filter box into the engine the AIT sensor is screwed into the side of the hose
on driver side intake manifold
on the intake
Intake Air Temp Sensor It should be located on the intake or close to the throttle body
It is located behind the IAC which is bolted to the Throtle-body. Remove the air intake connection to see better, take the electrical connector off and unscrew the sensor from the intake manifold
The Intake Air Tempature sensor is located on the air intake duct about mid way down the duct.
It's under the air intake on the thermostat bellhousing.
were is tempeature located
i have a 1999 grand am se with a 3400 sfi and it's under air intake on the thermostat bellhousing hope this help you out. good luck
This sensor is located on the air intake track. This sensor will only have two wires coming from itÊandÊthis sensor is also called the throttle body.
Located in the air intake plenum.
The IAT is part of the MAP sensor on vans before 2001. In 2001 they started putting it near the air box.
were is the cooling temperature sensor located on my 96 Plymouth grand voyager
The fluid temperature sensor is located on the left side of the transaxle. It is held in by a single bolt.
The AIT sensor is located on the plastic tube that runs from your air filter box to your engine intake throttle body. There is a two wire plug that attaches to the sensor. It is visible as soon a you open the hood on the right side of the engine bay.
The coolant temperature sensor on a 2001 Jeep Grand Cherokee is located on the T-stat. It is on the passenger side of the Jeep.
The error code p1193 on a 2001 Dodge Grand Caravan indicates that the intake air temperature sensor has failed. The sensor can be replaced by unbolting it, removing the wiring harness, and pulling it from the intake.
disconnect the temperature sensor located under air intake , on thermostat bell housing that should automatically turn on the fans