It is on the intake manifold closes to the TBI, it will be the black one.
The IAT Sensor on a 1992 Geo Tracker is the Intake Air Temperature Sensor. Replacing the air filter might fix this problem.
The IAT ( Intake Air Temperature ) sensor is located on the back of the air cleaner housing.
Temperature Gauge Sending UnitThe sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.To check it you will need a Multimeter
Temperature Gauge Sending Unit The sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.
Are you refering to the Temperature Gauge Sending Unit. If so; The sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.
Temperature Gauge Sending Unit The sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.
It will be located on the air intake tube after the air filter and before the mass air flow sensor.
The intake air temperature sensor can be found on the top of the air intake manifold. The temperature sensor should be labeled as such.
The IAT (Intake Air Temperature) Sensor is a Two (2) Wire sensor located close to the intake.
The air intake temperature sensor can be found on the top of your manifold intake. The sensor will be right in the middle of the intake manifold.
The intake air temperature sensor is located on top of the intake. In a 1990 Toyota Camry the air temp sensor assures the ECU the engine is running at optimal temperature.
Code P0113 indicates a intake air temperature sensor circuit high output. Check the connection to the intake air temperature sensor and if that is fine consider replacing the intake air temperature sensor.