Standing in front of the Jeep, it's at the very back of the engine, on top, next to the distributor, on the left. It should have a wire plug on top. you will need a special tool to remove the sensor, being careful not to break the wiring plug (remove the wiring plug first).
on the bellhousing easy one dont break it trying to get it out
on the back end of the transfer case right before the rear drive shaft
The plug or sensor above the oil filter on a 1996 Cherokee is the oil pressure sending unit. This sensor controls the oil pressure gauge.
The oil pressure sensor is on the rear top of the engine, next to the distributor cap.
The oil pressure sensor is on the top rear of the engine, next to the distributor.
You can not. The crankshaft position sensor is required to run the engine.
what engine size
It is in the engine block area.
In the exhaust pipe, near the engine.
Usually a crankshaft sensor is located on the bellhousing of the transmission
The 95 Lumina with a 3.1 engine does not have a temperature sending unit. Instead, the dash temp gauge is controlled by the engine coolant temp sensor. This sensor is located on the driver's side, top of the engine.
Which temperature sensor? There is an air-fuel charge sensor, and a coolant temp sensor.