Hey Matt==It is on the pass side of the engine just above the oil pan screwed into the block. You need to have a manual gauge installed long enough to see if the gauge in the car is accurate. If you still have low or no oil preasure with the manual gauge, the oil pump or other things are bad. GoodluckJoe
on the intake
The throttle position sensor is a potentiometer.
It will bolt up, but the manifolds, flywheel, wiring are different. Also the 1997 head does not have a hole in the rear for the temperature gauge sensor.
A 1997 Jeep Wrangler uses green coolant.
A 2002 Jeep Wrangler does not have a mass airflow sensor.
Use a 02 socket. The 2 sensor are located in front and behind the cat.
If you are getting a p0123 code on a Jeep Wrangler, it means that your throttle body sensor is not working properly. Once you replace this sensor, the code will go away and your Jeep?æwill run smoother.
You want to look on the intake manifold on the Jeep Wrangler.
how to replace the slave cylinder on a 1993 jeep wrangler
AnswerThe fuel pump on a TJ Jeep Wrangler ('97-'01) is located in the fuel tank. The fuel tank is located in the rear of the Jeep, under the cargo area, on the exterior of the Jeep.You have to remove the fuel tank to replace the pump.
The tps is not adjustable on a 2003 Jeep Wrangler.
How do you replace the clutch slave cylinder on a 1989 jeep wrangler
Bank 1 sensor 2 is the sensor on the downstream side of the catalytic converter.
T is right beside your throttle body(onthe right if your standing in front of your jeep)
yes it will fit1997-2006
No. different bolt pattern.
No, different bolt pattern.
YES YOU CAN, JUST MAKE SURE YOU BUY FULL DOORS FROM A TJ (JEEP 1997-2005 ONLY)
The correct factory tire size for a 1997 Jeep Wrangler is P205/75R15.
as far as i know it will. YES
No. Don't waste you time.
you jet some glass that fits a 1995 jeep wrangler