The 1989 Dodge Dakota oxygen sensor can be found on the top of the engine. The oxygen sensor will be on the back side of the air cleaner housing.
O2 sensor on 1990 Dodge Dakota is located on passenger side of exhast before catalytic converter. Most likely it has 4 wires.
The 4.7L 2002 dodge durango has 4 O2 sensors. ref. Chilton's Dodge Durango/Dakota 2001-03 repair manual. page 6-19 (Oxygen sensor - general info and replacement) The upstream oxygen sensor is located before the catalytic converter. The downstream oxygen sensor is located is located after the catalytic converter.
There are two, one on each side of the catalytic converter.
On the 98 u have two oxygen sensors an upstream and a downstream. The upstream oxygen sensor is located closer to the front of the truck by the transmission. The downstream oxygen sensor is located on down torwards the back of the truck along the side of the frame.
they are in front and after your cat
I have a 96 Dakota 3.9L and it is located above the Y pipe before the converter. There is also one directly behind the catalytic converter.
The oxygen sensor is located in the exhaust system on a 2005 Dodge Durango Hemi 5.7. There is a sensor located before and after the catalytic converter.
There is one on the manafold on the passenger side and there is one located on the exhaust between the converter and the muffler
The IAT sensor is located in the intake manifold
A 1999 Dakota does not have a mass airflow sensor.A 1999 Dakota does not have a mass airflow sensor.
It is in the distributor.
Inside the distributor
The oxygen sensors are screwed into the exhaust pipe near the catalytic converter.
Top of the rear axle.
The 1997 Dodge Dakota air intake sensor can be found attached to the air cleaner housing. The air intake sensor will be on the inside of the air cleaner housing.
A 2006 Dakota does not have a mass airflow sensor.A 2006 Dakota does not have a mass airflow sensor.
There is one on each side of the catalytic converter.
The crankshaft sensor is located on top of the transmission at the passenger side.
The oxygen sensor is mounted in the exhaust down-pipe
PO136 on a 2000 to 2003 Dodge Dakota (It may be true for other year Dakotas) means "Downstream oxygen sensor circuit problem (left cylinder bank)". This is the oxygen sensor that is located just past the catalytic converter on the driver's side and measures the oxygen level after the exhaust has passed through the catalytic converter. I
there are two. both are on the exhaust pipe(s)
they should be right before and after the catalytic converter
located on the passenger side of the bellhousing. It detects notches on the flywheel/driveplate
It is in the front of the catalytic converter.