The 1989 Mercury Sable 3.0 liter engine EGR valve is located on the firewall. The valve will be on the passenger side of the firewall.
Crank sensors are always located on the camshafts. The 1989 Pontiac Sunbird crank sensor is located on the head of the engine towards to end of the camshaft.
PCV Valve is located near front of hood on the engine block between the fuel injectors.
On the engine end of the upper radiator hose is the location.
The 1989 Oldsmobile EGR valve is located on the top of the engine, near the back. It is quite simple to change.
The 1989 Pontiac Firebird oil sending unit is located on the bottom of the engine. You will need to remove the oil pan in order to access the oil sending unit.
The 1989 Chevrolet S 10 pickup idle control valve is located on the side of the engine. You will find the valve below the fuel injector pump.
It is in the valve cover.
How do you replace valve stems and guides on a 1989 Jeep 4 Cylinder engine?
Remove the vacuum hose from your 1989 Oldsmobile 3.8 liter engine PCV valve. Remove the retaining bolts from the valve. Reverse the process to install the new PCV valve.
The pcv valve on a 1989 Camaro is located in the top of the valve cover. It plugs into a rubber grommet and is easily replaceable.
In the right rear of the valve cover.
What parts??? Body, engine, suspension???
Inside the alternator
where is the EGR valve on a 1989 mazda b2200
the oil pressure switch is located in the rear of the engine compartment on the drivers side under the valve cover
Front of engine, underneath the intake runners. This is for Quad 4 dohc engine. You can just see it if you remove the rubber hose from the throttle body to the air filter.
Not sure about the 1989, but 1990-1993 it goes into the valve cover. Look for a hose running to the valve cover and the PCV valve should be what is at the end of it pushed into the valve cover.
remove cowling it is on the passenger side valve cover
If you are referring to engine oil for a 5.0 V-8, the oil cap is located on the front of the passenger side valve cover.
Looking at the front of the motor, the egr valve is located on the right lower side of the carburetor.
The Exhaust Gas Recirculation Valve on a 1989 S10 is located in the valve cover. It is toward the front of the motor.
right above the oil filter
thermostat is located under radiator cap!