Its on the slave cylinder which is on the front of the transmission just left of the front engine mount bracket. It looks just like a brake bleeder screw.
The 1986 Honda Prelude does not have a clutch cable. The 1986 Prelude has a hydraulic clutch instead of the clutch cable.
Does a 1998 Honda prelude have a clutch cable
the SI is not carborated it is fuel injected.
You will find the bleeder valve on the Slave Cylinder, which is mounted on the front of the transmission, by the radiator. You will find it in the front and center of the engine compartment.
Yes it does
Look at the back of the engine where the slave is for the clutch. The bleeder is right there. Just follow the hyd. line on the right side.
You can't aprrently on a hyrdraulic clutch, which these have that adjust automatically.
You have 2 switches A and B above clutch petal under dash
Same as for the brakes. Locate the bleeder, slack it and re tighten. Have someone pull in the clutch and hold, you release the bleeder, then tighten it while the clutch is still held in. Once the bleeder is tight, release the clutch and repeat till all the air is out. Make sure to refill the fluid.
85 Lude, old school cable clutch... No hydraulics (fluid)
No drop it from under the car.
You bleed this the same way as a brake line. 2 people, full reservoir, dot 4. Make sure the bleeder is easy to open. With bleeder closed, have other person pull in the clutch and hold it in,you open the bleeder to let out the air or fluid, then close the bleeder, when you have it closed, then tell the other person to let go of the clutch. Repeat this till all the air is out.