0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
On a 2003 Pontiac Montana which caliper mount bolt has the rubber grommet the top or bottom?
Both the upper and lower caliper bolts must have the rubber boots on them. Otherwise, dirt and moisture will get in around the bolts and cause them to stick in the caliper mounts.
2006 Ford E 350 caliper flange bolt torque spec?
what is the caliper bolt torque specs for a ford 97 club wagon
What bolt size is needed with serpentine belt tensioner for a 2000 Pontiac Montana?
15mm socket will fit the bolt. Do you mean what is the length of the bolt? I mean the length of the bolt.
What size socket for a 2006 expedition 4x4 front caliper bolt?
9mm hex
What are the Chevy 3.4l head bolt torque specs in a 99 Pontiac Montana?
The 1999 Pontiac Montana 3.4 liter engine cylinder head bolt torque specification is 150 pounds. The cylinder head bolts should be torqued in 50 pound intervals.
What size caliper retaining bolts for 2006 Ford F-150 truck?
what size of socket do i use to loosen caliper retaing bolt on ford f150 truck
What size is the caliper bolt on a 2006 dodge durango?
is a metric size 13mm on a hemi but i guess the 4.7 is the same
What size are the rear brake caliper bolt for Lexus ls 430 2004 for tap size?
Take the caliper to a machine shop and have the broken bolt removed or just replace the caliper. If you do not understand the bolt sizing, you are not equipped to retap the caliper.
What is the rear caliper bolt torque on a 2005 Honda Odyssey?
caliper bolt size 2007 Honda odysey
How do you take plastic bolt routing diagram off head in a 1999 Pontiac Montana?
Just under the belt routing diagram, there is an 8mm bolt. Take it off. You're done.
What size bolt is it to remove the caliper bracket on a 1999 f150?
the caliper bolt should be a 13mm and the bracket or "bridge" bolt should be an 18mm or a 21mm
What size is the bolt to the brake caliper for 1994 Cadillac sedan deville?
The Rear Caliper Bottom Bolt head size is 12 mm. The Top bolt is enclosed only making it a slide bolt therefore you cant and really have no need to remove it. So the only bolt you should remove is the bottom 12mm head bolt. Then there will be a 14mm bolt that will hold the Emergency Brake Cable Bracket to the Caliper. Loosen this bolt and remove the Emergency Brake Cable Bracket from the Caliper. Then pry the bottom of the caliper up off the disc. This will allow you to swing the caliper up then push the caliper back to slide the caliper off the enclosed bolt slide at the top of the caliper. This will allow access to the inside and outside pads to remove them and allow you to press and rotate the Piston (Push and Twist-in Pistons) back into the Caliper with the right Brake Caliper Compression tool. The rear two Caliper Bracket bolt head sizes are 18mm. You must remove the Caliper bracket in order to remove the rear brake disc. The Front Brake Caliper Bolt is a 3/8" Allen head bolt. There will be two bolts holding the front calipers to the Spindle. The Front calipers are standard push-in Pistons.
