Check the control switch on dash (if any) labeled with a light bulb symbol
My Interior lights worked when I turned them on manually with the roll switch, but when I set the switch to neutral and placed the auto switch to on, so that when the doors were opened the light should come on, they would not.
Answer: The little push switch located on the side of the dash when the door is closed its pressed in by the door, when the door is open the switch springs out and the light comes on. If this switch is bad or has a short (jiggle) interior lights wont work when door is open and dash is set to AUTO. Replace!
the fuse is blown. they are on the same fuse
use your mom
change the headlight switch !
The fuse probably blew that controls the dashboard lights.
where is the heater control valve on a 1994 2500 suburban
No All you need is a good working vise, 4 inch or better
check fuses
Check fuse panel for blown fuse.
why do the back lights stay on when the car is off and the brake release is checked on a 1994 Honda accord
Working brake lights are important for safety reasons while driving. It is important to check all of the wiring, if the brake lights are not working and the fuses and bulbs have been checked.
When the signal lights are not working on a car, there are a couple of things that could be going on. One could be that the bulb needs to be replaced. The other possibility is that the signal relay needs to be replaced.
If a 1994 Chevrolet Suburban is not getting hot, it may need to heating core replaced.