0
Why do you put back the brake clips for brake pads on vw golf?
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you change the brake pads on a 1987 Volvo 240DL?
Put the car on jack stands and remove the wheels. Locate the calipers and brake pads and remove the pins and clips from the calipers. Slide out the old brake pads and push the piston back to make room for the new pads and shims. Slide in the new pads and shims and put the pins, clips and cotter pins back in. The front and rear replacement process are very similar, but have different pads and shims.
Do I need to use the metal clips when I replace the brake pads on my 2004 Isuzu ZRodeo?
usually the metal clips are anti-rattle clips to keep the brake pads from chattering in the caliper when braking, they also act as retainers for the pads
What type of brake pads do you need for Volkswagen golf?
Volkswagen golf ones
How do you install anti rattle spring to front brake pads?
It usually clips between the inner pad's back and caliper.
How do you install a anti rattle clips on a KIA sportage?
These clips are attached to the front brake pads to keep them from rattling inside the assembly. If you are doing a brake job, just notice how the clips are attached when you remove the old pads, then reattach them. If they are broken or missing, get a new set where you got the pads (the pads generally don't come with clips). don't quite understand question. whre are you trying to put these clips ?
How do you change brake pads on CITROEN C3?
In order to change the brake pads, you must first remove the wheel. Remove the retaining clips and the brake pads will come off. Reverse the process to install the new pads.
How do fix the rattle noise on the rear brake pads of ford focus diesel?
Ensure the anti rattle clips/springs are attached to the brake pad or it will rattle. Some cheap pads do not vome with these clips/springs.
What are the steps to replace front brakes on a 1989 Volvo 240 DL?
Put the car on jack stands and remove the wheels. Locate the calipers and brake pads and remove the pins and clips from the calipers. Slide out the old brake pads and push the piston back to make room for the new pads and shims. Slide in the new pads and shims and put the pins, clips and cotter pins back in. The front and rear replacement process are very similar, but have different pads and shims.
There is a grinding noise when applying the brakes to stop the noise comes from the back brakes i drive a 1.4 vw golf?
brake pads could be worn out. would it be safe to drive for now if the front brake pads are ok?
Can you replace back brake pads using front brake pads?
It would be unusual to have the same brake pads front and back. That is not to say it does not happen but normally the brake pads on the driven wheels are bigger than the passive wheels.
What is the most common reason for brake squeel when the pads are good?
Pad insulators, anti rattle clips, or calipers are loose. The squeal you hear is the result of vibration of the brake pads.
You just replaced brake pads on a 2000 grand am an they are squeaking does any one know how to fix that problem?
Disc brake squeaking starts with high temperatures on the face of the pad and then it is magnified at the back of the pads where they contact the caliper. When you replaced the brake pads did you have the rotors machined? You should because the run-out on the rotors can be part of the problem. Also you have anti-rattle clips; were they installed correctly? If you did these correctly then try this: Remove the brake pads and on the back of the pads apply a couple of heavy beads of RTV silicone and let it set up for 20 minutes then install the pads; that should take care of the noise.
