0
Why does my 1995 Firebird make a grinding sound when you put it in park and turn off the ignition What could this be?
Wiki User
∙ 15y ago
sounds transmission related or possable flywheel related That would be the power headlight motor!!
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
You heard a grinding noise when you would turn and you filled up with power steering fluid but you still hear this noise - What could this be?
I would guess that it is the wheel bearing. is it a grumbling sound or an all out grinding? If it is or was a grumbling sound and has turned into a grinding it is probably the wheel bearing.
Grinding sound in a 1996 Bonneville?
depends on where the grinding id coming from
What would cause a grinding sound under hood when in drive but sitting still?
A bad transmission. The sound is from metal grinding on eachother.
Although the car starts what is the cause of a grinding sound when you turn the cars ignition key?
This is probably the starter going bad. You should have it looked at as soon as possible or replace the starter yourself.
What causes a low grinding sound near the Alternator when turning the Van off?
The bearings on the alternator could be going bad. Remove the belt from the alternator then spin the alternator by hand to listen for grinding.
What would cause a grinding or rattling sound when accelerating from a stop or when turning?
if its a front wheel drive vehicle then it could be the axels
What causes a metal sound when turning left?
A few things could be causing a grinding sound when turning. It could be a cv axle, ball joint, tie rod end, or bracket pin steering.
What sound does it make when rotors are bad?
Grinding
What would make a grinding like a metal to metal sound when you turn your wheel mostly to the right?
Could be a bad wheel bearing.
Why does your car make an awful grinding sound when you turn especially to the right and vibrates slightly when stopped?
The "awful grinding sound" might be a problem with your power steering
Grinding or rubbing sound in the front end of a 2002 Ford Focus?
A wheel bearing could be going bad in a 2002 Ford Focus if a grinding or rubbing sound is heard. A trip to a mechanic is advised as a bad wheel bearing that's not fixed can lead to damaged brakes.
You turn the ignition and all you hear is the turning sound but it wont start?
may be a bad starter..... or if the engine is cranking with no start it could be the ignition wires
