Asked in Toyota Tacoma
Will coil spacers work on a fabtech 6 lift for a Toyota tacoma?
Yes they should work but why use them? With the Fabtech kit in place, the truck is already lifted quite a lot. If you install coil spacers, the coils will be stiffer and driving characteristics will change especially when doing turns. I would try driving a truck with coil spacers before having them installed and see if I like it or not. Yes the ride is a little stiffer but its definitely worth it to clear a bigger tire ...
Asked in Rules of the Road
If a truck ahead of you is signaling a right turn should you stay behind truck until the turn is completed?
Generally no, but in some situations yes. If this is a small truck, and there is another lane to the left of the truck you can safely change to, you can pass the truck on the left as it makes a right turn. If the truck is one that requires wide turns or indicates explicitly that you should not pass on turns they you should not do so. There is nothing forbidding you from waiting behind the truck as it turns and then...
If a truck that has a green Yield For Left Turn suddenly turns in front of you and you hit the truck who is at fault?
it is the truck that terned in frount of you criminal justice student
Asked in Car Starting Problems
What is wrong if car starts to turn over then won't but turns over after several tries?
My truck has the kill switch the kind that is a long little switch the thing is it is on the postion but the truck still is not turing on. I replaced the ignition switch and have a new battery. How do I just remove this so that i can just turn on my truck, 1996 ford ranger. ...
Asked in Check Engine Light
What does a warning light with engine protection mean in a freightliner classic XL truck?
Does it say Engine Prot? means that you might be low on fluids such as coolant and the longer you run with it it, it will start to slow down the engine until u stall out....happen to my cat c7 in my freightliner. and it turns out i blew my cooling system. ...
Asked in Toyota Celica, Timing Belts and Chains
What could happen if the timing belt brake while driving a Toyota celica 1993?
YOUR car will Immediately sputter and backfire, followed by a complete stall. Your timing belt (or chain), is directly synchronized with the cam shaft.(crank shaft turns cam shaft, via belt or chain)...Tom ...
Asked in Cars & Vehicles
What was the gear ratio 26 spline 10 bolt posi rear in the 1978 elcamino?
The quickest way is to jack up the rear of the car or truck and turn the rear wheel 1 complete turn and see how many revolutions your pinion yoke turns. if it makes thee revolutions and a little over it could be a 308 four turns and a little over would be a 410 ect.. ...
Asked in Chevy Blazer, Chevy Blazer S-10
Why does my 2001 Chevy Blazer Stall on turns and deceleration?
it something with fuel delivery maybe a bad fuel pump, filter, or fuel pressure regulator ...
Asked in Chevy Impala, Chevy Silverado, Chevy Tahoe
Will 26 inch rims fit on short bed cheverolet truck?
They will fit on the truck but the only problem you will have is that the front rims will rub against the frame of the truck when u try making sharp turns. You can fix it by either buying coil spring spacers at auto zone for $15 and put them on the springs to lift it up a little. or u can get a truck lift at a body shop which is more expensive. Either way 26" on a Chevy is...
A guy gets out of his house he jogs 4 a little bit then turns left then jogs 4 a little bit then turns left then turns left jogs 4 alittle bitthen turns left he returns home and is meet by 2 mascked?
men who are the 2 masked men?? Baseball
My 1992 f 250 turns off in reverse whats going on thanks?
Its possible that the lower gear ratio in reverse could be putting an increased load on your engine which an older truck may not always be able to handle, thus causing you to stall out. To answer it more accurately, I'd need to know exactly what you mean by "turning off" ...