Odds are you need a fan switch, It is very common for the high on GM fan switches to go out.
Paul G. Blazer High School was created in 1963.
Kevins
The high speed relay for the blower motor would be found under the hood, on the passenger side of the firewall, close to the blower motor speed resistor.
sounds like the resistor board has blown, on the highest setting it has no resistors, hence the reason it still works
Under the hood, on the firewall, passenger side, close to the blower motor. If the blower motor resistor is burned out, you should still have the high speed function.
how to change upper tie rod on 96 chevy blazer
The high speed of the blower is controlled by a black rectangular relay on the firewall facing the engine compartment on the passenger side (I think there are 3 relays there) one is for the high speed. If you open it and the plastic base looks melted > it's most likely the relay I believe the ralay is under-rated bacause if you use high speed alot (like I do) it burns out prematurely. I had to replace mine in my 1996 Blazer two times in 140,000 miles
toyotas have a resistor bank in line with heater motor each speed has a different value resistor. there is no resistor on high speed. it is located on passenger side in heater duct I thank it has two screws holding it on when you get it out you will see the resistors burned
The best way to take care of a ball python in the winter is to make sure your heater is on and make sure to provide fresh water and fresh food every day. :) dont forget to have your heater on at a high temp.
The heater motor speed resister is burned out.
I believe you have a relay that runs the high speed for the heater fan motor. The relay should be located in the power distribution box under the hood.
Possibly