0
Why would 4wd light or truck not go into 4wd when switching the truck into 4wd not work on a 97 mercury mountaineer?
Wiki User
∙ 12y ago
the switch might have went out this is a common problem that hapens with bush butting 4x4 or turney nob wich ever it is put it to the 4x4 spot then hit the gas to see if it is relly in 4x4 or if the back tire just spin
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the fuse box on a 2006 Mercury Mountaineer?
Where the fuse for the side rail on my truck
Where is the computer module on 2003 mercury mountaineer?
The computer module in a 2003 Mercury Mountaineer is located behind the rear right panel in the truck space. The rear right seat belt panel must be removed and then the lower panel. The module is located beneath a green plug.
How do you change front wheel bearings on 2004 mercury mountaineer?
My front wheel bearings just went in my 04 mountaineer, and we tried to replace them ourselves, but in order to get to the bearings you have to have the truck up on a lift, so unfortunately we had to send it to a mechanic.
How do you find out if Mercury Mountaineer is awd?
Look under truck at drivers side front between door and tire. If ya see the the front axle driveshaft andya have NO auto/4x4 hi/4x4 lo select switch above cigarette lighter then its AWD. i have a 2000 mercury mountaineer awd. Also the 5 liter v8 was awd.
How can you open the hood of a 1997 Mercury Mountaineer if the cable doesn't release the latch?
On my 97 mountaineer you cannot open the hood with the release inside the truck. Standing in front of the truck on the drivers side behind the grill the cable is located to pop the latch. Carefully pull out the bottom right side of the grill and you have to have a skinny arm reach in and pull downward on the cable itself this will pop the hood...
How do you replace lower ball joints on a 1997 Mercury Mountaineer?
Those are pressure fitted with a special tool. Your better off bringing your truck to a automotive repair shop to have them done. I couldn't find the right tool to do the job anywhere.
Is there any way to turn off the Service Engine Soon light in a 2002 Mercury Mountaineer without visiting the dealership and waiting for 2 hours?
Yes, take it to an independent reapir shop and wait for one hour. If you understand the check engine light and required diagnosis, you would make arrangements to drop the truck off at an independent garage that specializes in this. Find one through the local Snap-on Dealer.
How do you set the radio clock on a 1999 mercury mountaineer?
It depends on the model radio you have, you can Google 1999 owners manuals for your truck and download a free pdf. But 97-2000 had numerous probs w/ radio. For most models you hold down the clock button or RDS button for a couple seconds then use the seek button till you get to hours the push the button again till you get to minutes. Alot easier to go here 1999 mercury mountaineer owners manual pdf
Why would the brake pedal on a 1997 Mercury Mountaineer go to the floor and the abs kick on sometimes when the truck is almost stopped?
Take the vehicle to the shop as soon as possible. You either have a bad master cylinder or wheel cylinder, or a broken line. This could be very dangerous.
How do you find the combination to the lock on the 1998 mercury mountaineer?
in the back of the truck where the jack compartment is you will find a box with wires going to it on the back side of that box is a sticker. you are going to need a small mirror to read it unless you take the plastic side panel off hope this helps
How do you install a starter on a 2003 Mercury Mountaineer?
# Disconnect negative battery cable # Raise and support the truck # Remove the protective cover from the starter motor solenoid terminals # Disconnect the wiring from the terminals on the starter motor solenoid # Remove the starter mounting bolts and detach the starter from the engine
What does LT stand for on a truck?
Light Truck
