0
There is to much heat from the exhaust manifolds.
There should be medal factory heat sheilds bolted to the exhaust manifolds to pervent this from happening. INSTALL HEAT SHEILDS
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
1995 Toyota Camry Wires to spark plug keep burning in half. I have replaced the wires once and they burned again immediately. Any suggestions?
Spark plug wires should not overheat from the electric current, so I would be supspicious of an exhaust leak or some other outside heat source causing problems. Where is the wire burning?
Will broken spark plug wires keep a 2003 Malibu from starting?
Broken spark plug wires will keep almost any car from starting.
Will Water in your spark plugs keep the car from turning over?
Water around the outsides of the spark plug may keep the car from running due to poor spark plug wires, but the engine should still turn over.
Why does your ford ranger keep back firing and rattling after changing the spark plug wires?
because you did it wrong
How do you change spark plug wires for a 2004 gmc sierra?
Chase the sparkplug wires back to the coil pack. Depending on the size of engine is going to determine how many wires there will be. Keep in mind where you unplug the wires from the new wires will need to go back the exact same way to keep the firing order the same.
Why do Misfire codes keep coming back you changed spark plugs and wires distributor and rotor?
I would help to know what year and model vehicle you have but, you may have a bad fuel injector.
Where is the right place to put the silicon stuff that comes with the new ignition wires?
The silicon stuff is to help keep the spark plug boots from sticking to the spark plug, so put it in the spark plug boot.
How to route a 1998 Chevy Malibu spark plug wires?
well on how to route the spark plug wires, you just need to keep them away from the exhaust, and make sure to keep them away from any moving parts in the area. Zip ties work wonders on these, and just ensure that they are in their correct location for the corresponding cylinder.
What causes a 1982 Honda Silverwing 650 to keep burning out spark plugs?
Wrong heat range plug for the fuel and/ or riding conditions
Why does your distributor and rotor keep going bad on your 2003 Chevy s10?
Replace the spark plug wires, too much resistence in the old ones.
Your spark plugs keep burning out and the engine is losing power what is the cause?
There is not a lot of information to go on from the question as posted. When an engine is in proper operating condition, the spark plugs should not be "wearing out", on a regular basis. From the information at hand, I would suspect the wrong heat range plug is being used. Check to see what spark plug the engine manufacturer recommends for your engine.
Why would a 350 engine keep missing with all new spark plugs?
You did not specify year so I will assume it is an older one. If it is spark related then a cracked distributor cap ( so small you may not see it ) or rotor, and dont forget the plug wires, one or more may be bad or grounding against the engine before the plug. I suggest replacing them all ( cap, rotor, and wires ) then check timing.
