no, at least not if your T100 has the 60/40 bench. The 4runner seat mounts are closer together than the mounting holes on the T100. I put a 97 4runner drivers seat in my 96 T100, but it required lots of cutting drilling and a handful of grade 8 bolts. Can be done, just not straightforward.
In the gas tank. Lift the rear seat passenger side seat. Under the carpet there is an access panel to get you into the pump.
there is a fabric pull loop (similar to seat belt material) hidden within the upper and lower seat in the middle of the lower seat. gently slide a finger between the upper and lower seat and locate the pull loop. pull the loop up and the lower seat will release and move up and toward the front seat.
The fuel filter 4runner v6 sr5 is located under the car, underneath the the front passenger seat behind the chassis..
My 1997 4runner, in between the seats where the seat belts are...there are 2 cloth tabs, one on either side, pull hard and lift bottom portion of seat upwards and toward the back of the front seats. i couln't figure this out either! I believe it is under the rear passanger seat right behind the front passanger seat. You have to pull the headrest out, pull the hand on the seat and fold it forward, the jack will be right there.
If it has a passenger air bag I wouldn't......
NoNo
There are 4 bolts holding down each front seat, just unbolt them and unhook any wiring under the seat and pull the seat out.
If I rember correctly, the relays are located in the kick pannel on the left in the back seat area, where the back seat passengers foot sit's near the floor.
look where the seat belt (female-end) comes out from...dig around and there should be a cloth strap, pull it and the bottom seat will fold up toward the front seats.
No
To remove the seats from a 1995 Corvette, you will need to remove the front and rear nuts from the seat frame studs. You will?æalso need to remove the lug wrench that is attached to the seat frame studs.
NO you need to make sure you have power to the seat