0
You are getting a lot of heat through your 1977 Corvette firewall and you know it's not the heater and ideas?
Wiki User
∙ 18y ago
you need heat shields under the carpit if they are missing.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
Where can you find a manual or diagram that sHow is the location for a heater core for a 1985 Corvette?
Just follow coolant hoses from rear of engine to where they go through the firewall.
Where is the heater blower motor on a 1980 Corvette?
right side firewall under right fender
How do you change a 1972 Chevy Corvette heater core?
The heater core is on the passanger side, located behind the bower motor housing on the firewall. If the car doesn't have AC it is not a difficult project. Remove the heater hoses from the firewall and then remove the screws that attach the cover to the firewall. The heater core rests inside.
Heater core change 1972 corvette with AC?
Remove the heater core retaining bolts. Remove the heater core water supply hoses. The heater core will come out. You can access the heater core in your 1972 Chevrolet Corvette through the passenger side kick plate.
How do you change a heater core in a 1976 Corvette with air conditioning?
1968-1982 Corvette heater cores typically begin leaking due to a breakdown in materials dropping anti-freeze and coolant on your Corvette's carpet. This is not a pretty sight. Removal of the heater core takes place from inside your Corvette. First the RH side lower dash pad must be removed, then access can be gained to the inner heater box. Remove all ductwork (windshield defrost, floor duct, side ducts, etc.). The main inner heater box is supported to the firewall by 4 to 6 studs, these stud plates are riveted to the inner heater box. By removing the nut on the opposite side of the firewall the inner box can be removed from the Corvette. The heater core is mounted with straps inside the inner heater box. Once the inner box is removed from the Corvette, the heater core can be replaced and reassembly can begin. At this time it is also a good idea to replace all the seals in your Corvette's heater & air condition system. Seal kits for 68-77 & 78-82 Corvettes include ductwork seals, inner box seals, heater/ac flapper door seals and firewall mount seals for internal and external heater boxes. Replacing these seals not only improves your Corvette's heater & AC performance, but also eliminates air drafts which are common on all C3 Corvettes. From all of us at Zip-Corvette.com
Where is the heater core on a 1992 Dodge Dakota?
Open the hood on your truck, look at the back firewall. You will see two water hoses sicking out. That is where your heater core is located. As for getting it out through the dash? Good luck.
Where is the firewall in a 1997 blazer?
The separation between the engine compartment, and you, is called the firewall. The Steering shaft, from your steering wheel runs through the firewall, the heater hoses run through the firewall, the power brake vacuum unit is connected to the firewall, your ignition wires etc run through the firewall.
1989 corvette heater blows cold air even though both lines are hot going to the firewall do you have to change the heater core and if so how do you do it?
I would say that your heater core is ok...it sounds like you have a bled door promlem in the dash.
Where is heater control valve for 99expedITION?
if it has one it is in heater hose at firewall if it has one it is in heater hose at firewall
Where is the heater inlet hose on a Hyundai accent?
The heater inlet hose on a Hyundai Accent is in the back of the engine compartment. It goes through the firewall to the heater core.
Can heater core be replaced in 1997 Chrysler Concorde by going through oppossite side through firewall?
The heater core can only be accessed by removing the dash and HVAC housing.
How do you bypass the heater core on a 98 Ford Expedition?
Remove the two hoses that go through the firewall to the heater. Connect these two hoses together.
