answersLogoWhite
Heater Cores and Blower Fans
VW New Beetle
Ford Expedition XLT

Your ac and heat is not blowing out in your 99 vw beetle but the blower motor is fine Any ideas?

678

Top Answer

User Avatar
Wiki User
2005-10-21 05:20:58
2005-10-21 05:20:58

Check your heater core also.

1

Related Questions

User Avatar

Blower motor: remove the glove box and you will see the blower motor and blower resistor.

User Avatar

The blower motor, on your 2001 Volkswagen beetle, can be found in the front trunk compartment. The blower motor will be attached to the firewall, on the passenger side.

User Avatar

Begin by removing the wiring harness from the back of your 1974 Beetle blower motor. Remove the blower motor retaining bolts. Remove the blower motor fan. Reverse the process to install your new blower motor.

User Avatar

Blown fuse, defective blower motor, or defective blower motor resistor pack.

User Avatar

Blown fuse, defective Blower Motor Resistor Pack, Defective Blower Motor, or Defective Blower Motor speed control switch.

User Avatar

Bad Blower motor fuse Bad blower motor resistor Bad blower motor Bad switch Evaporator plugged- not allowing air flow

User Avatar

Bad blower motor fuse? Bad blower motor resistor pack? Bad blower motor - checck to see if it is getting power--if so bad motor Bad switch?

User Avatar

The blower is drawing to many amps. Have it checked. If that's not it. your blower motor is shorted out. Om the motor to the frame.

User Avatar

need to remove the the glove box and it's support brace. Then you have to pull the lower section of the instrument panel outward and unclip the blower motor. Then pull the blower motor and fan straight down to remove it.

User Avatar

Likely the blower motor is bad, causing increased current and blowing the fuse. Replace the blower motor.

User Avatar

If the blower motor does not function, it is blown fuse, defective blower motor, defective blower motor resistor pack, or in rare instances a defective blower motor speed control switch. Check the fuse. If it is OK, apply 12 volts directly to the blower motor and if it runs, you probably have a defective Resistor Pack. Very common problem. The only fix is to replace it.

User Avatar

WEll, Since the ABS isn't as wire intensive as the blower motor and the blower motor is constantly turning, my first inclination woule be to disconnect the blower motor assuming a shorted out motor. This should be much easier than tampering with the ABS and much less detrimental if that isn't the problem.

User Avatar

Your air conditioner blower may have stopped working because the blower motor isn't working. You can replace the blower or replace the air conditioner.

User Avatar

There might be a bad fuse causing the heater to not work. Check the fuses if they are all ok you may have a bad blower motor. when you turn the heater on and no air is blowing then it is your blower motor.

User Avatar

There is an electrical short to ground in the fan switch or in the blower motor itself.

User Avatar

If the heater is blowing the fuse when the blower is turned on, I would suspect the blower motor is defective or locked up. If the A/C is blowing a fuse, suspect a bad clutch, or locked up compressor.

User Avatar

if its not blowing at all, your blower motor is bad. if its blowing but not cold, you probably just need a shot of coolant. tour blower motor is norm located under the dash on the passenger side, below the glove box.

User Avatar

most likely cause is one of three relays for the blower motor, usually located on the firewall under a plastic covering or near the battery If you do not use the blower motor very often like your car sits for a few weeks mositure gets in the blower motor and causes rusting which can cause your blower motor to lock up. Best suggestion is to run you air conditioning unit on high for about half an hour every once in a while.

User Avatar

Blown fuse, defective blower motor resistor pack, defective blower motor, or defective fan speed switch.

User Avatar

I think you have problem with the blower resistor. Please follow the procedure to check. * remove the connector to the blower motor. * use voltmeter to check the voltage. * connect one probe to the ground and the other probe to the 3.0R/w of the motor supply. * turn on the the blower motor with dial, you should read supply voltage, 12Vdc. * if you have positive voltage at the 3.0R/w then you should check the blower resistor and blower switch. blower switch supplies battery negative to the blower motor through the blower resistor. if you need further help please just let me know.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.