answersLogoWhite

0

If it's the rear a/c fan switch, they have had problems and replaced them under warrantee when under warrantee. I am working on the 4th one in mine now and found that the switch heats up really quick. they were made in India and that's the first time I've seen a GMC part from other than Mexico or Canada. The heat problem in the switch seems to come fron arcing and I think it takes the heat temper out of the small spring behind the triangular contact on back of the little roler/gear plate inside the switch. I'm about to clean the heck out of the contact and replacethe spring, beyond that I will turn the three contact points dowm a bit and it should make better contact and work better. Good luck! If this helps or you need more info, I'm at mcgill1114@aol.com

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What does switch' MAC address table keeps track of?

The switch keeps track of which computers (identified through their MAC addresses) are connected to which switch ports.The switch keeps track of which computers (identified through their MAC addresses) are connected to which switch ports.The switch keeps track of which computers (identified through their MAC addresses) are connected to which switch ports.The switch keeps track of which computers (identified through their MAC addresses) are connected to which switch ports.


I have Safari 1.3.2 on your Mac OSX 3.9 Safari keeps crashing any suggestions?

You should try to upgrade it to Safari 3.1.2.


Why would a 1999 Stratus dash lights not come on but all the gauges work fine?

It neeeds to be checked out as the printed circuit can have problems. The switch that controls your driving lights ie headlights, turn signals etc. could be bad. Check the fuse first. If it keeps blowing the switch could be shorting out to gnd.


Brake pedal switch keeps going out on 1988 mistubishi pick up. replaced 4 times already. what could it be?

It could be one of your wires leading to the break light it touching and shorting on another wire. Or try replacing the fuse somtimes that might help.


Is xbox penny fix safe?

yes, just make sure to wrap the pennies so that no copper is showing. This keeps the board from shorting.


You have a fuse that keeps shorting out when you press on your brake pedal of your Ford Taurus sw what is the cause?

Could be a short in the brake light switch or a bad bulb.Try removing all of the tail light/brake light bulbs and step on the brake pedal to see if the fuse still blows.If it does it is a brake light switch problem or a short in the wire harness.If not it's a bad bulb.


Your starter keeps shorting out no wires are touching and kills the battery when trying to start What could be the reason for the starter shorting or grounding out?

If you have just replaced this starter then you probably have it hooked up incorrectly. If it is still the same old starter, then it has shorted out inside and needs to be replaced.


You have a 98 ford windstar gl the rear wipers cycles one time stops for 5 second cycles again keeps doing this the motors been replaced with a reman whats wrong?

== == Control switch ? Does it have a delay function on the control switch on the wiper control stalk? This may be the way rear wipers are designed to work. I know this is normal in the 2001


What keeps burning out the brake light switch?

its the screw by your paddle


Hazard push-in switch keeps popping out is it easy to rewire to new switch fitted on dashboard?

No This is not easy. It is easier to replace the signal light switch assembly


What type of government or monarchy is in control of Egypt?

The king (pharaoh) keeps control of the government


The power door locks on a 2000 mercury cougar are not working and the fuse keeps blowing any ideas?

You have a wire shorting somewhere. First place I'd check is where they run from the frame into the door.