answersLogoWhite

0


Best Answer

there should be 3 bolts attaching the alternator, 2 short bolts and 1 long bolt

User Avatar

Wiki User

โˆ™ 2008-07-31 22:14:23
This answer is:
User Avatar
Study guides

Where I can purchase purchase HID Fargo ID card in Dubai

โžก๏ธ
See all cards
3.33
โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…
3 Reviews

Add your answer:

Earn +20 pts
Q: How do you remove alternator on 1997 Chevy Suburban 1500 5.0L I have removed the belt 2 screws and wires and it is still is not loose. Is there an assembly diagram?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove tail light assembly from 2004 suburban?

The tail light assembly on a 2004 Chevy Suburban can be removed by taking out the retaining screws and twisting the bulb assembly. The assembly can then be pulled from the vehicle.


How do you replace a daytime running light on a 2004 Suburban?

To replace the daytime running light on a 2004 Suburban, you will have to first remove the two metal pins that can be found on top of the headlight. The headlight assembly can be removed next. Pull out the plugs that are connected to the headlight assembly. Replace the bulbs and then reconnect the assembly.


How do you replace the alternator on a 1987 Honda Civic DX?

Disconnect the negative battery cable. Remove the air cleaner assembly if necessary. Disconnect the electrical connectors from the alternator. Loosen the alternator adjusting bolt or nut and through-bolt and remove the alternator belt. Remove the alternator adjusting bolt or nut and through-bolt and remove the alternator. If necessary, remove the mount bracket bolts and the upper and lower mount brackets. Installation is the reverse of the removal procedure: put the alternator in place and re-bolt mount bracket (if removed). Engage the electrical connectors and install the air cleaner assembly (if removed).


Replacing the alternator on a 1995 V6 Contour Chilton's says exhaust and shaft have to be removed Do they?

yes, once the alternator is removed from the bracket, the axle and exhaust interferes with the removal of the alternator from the vehicle.


How do you change an alternator in A Pontiac Aztec?

you have to remove the washer fluid tank, battery ,and full windshield wiper assembly. there are three bolts that must be removed on the alternator, plus two wires. The alternator sits way in the back under the wiper assembly(passenger side). Almost impossible to get to, right against the firewall, must use a small ratchet wrench, NOT SOCKET-TOO BIG. Hope i could help


How do you replace the fan belt on a 1968 Chevrolet Impala SS?

The alternator is the adjustment point. Loosen the bolts holding the alternator to the engine and slide the alternator in towards the engine. This will allow you to remove the fan belt. However, if you also have power steering, the power steering belt may have to be removed before the alternator belt can be completely removed. Loosen the bolts holding the power steering pump assembly to the engine and slide the pump towards the engine to remove both belts.


How do you replace the alternator on a 1997 GMC Safari AWD?

must removed the shield that covers the the fan in front. once that's removed you could get a better clear area to get to the alternator.


How do you remove the tail light assembly lens in a 1998 Chevrolet Suburban so as to be able to replace a burned out bulb. The 2 hex screws alone don't seem to be the entire mounting method?

I believe your Suburban is the same as my '96 pickup. Once you've removed the two screws there are two tabs on the outside of the assembly. Simply rotate the assembly around towards the outside of the body and push in on the other side to disengage the two tabs. Should come right out.


How do you replace the headlight assembly located on a 1997 Chevy Suburban?

There are 2 hex shaped rods protruding from the top of the headlamp assembly. You can see these above the headlight after you open the hood. Just use a small socket (5/16" I believe) and unscrew these 2 rods and the headlight assembly can be removed . . . (it drops out of the front) . . . thereby exposing the headlight bulbs.


How do you remove the spare tire on Chevy Suburban?

Removing a spare tire is easy to do from a Chevy Suburban. The tire is removed with the tool that is located on with your jack.


How do you remove Headlight assembly on 95 Olds Cutlass Ciera?

The headlight assembly on a 95 Olds Cutlass Ciera is removed by disconnecting the wiring harness and removing the bulb. The assembly can then be unbolted and removed from the vehicle.


Where is the PVC on a 1991 Buick Century 3.3?

It's located behind the alternator, you can easily be removed if you temporary take out the alternator.

People also asked