0
The blower motor does not blow any air out of the vents in my 1995 GMC Yukon. How do you remove the rubber casing from the outside of the blower motor to change it?
Wiki User
∙ 16y ago
Should be located at the passenger side firewall - some are removable from outside the vehicle - others inside behind the glove box - check to see if you are getting full 12 volts to motor Remove fan motor and check to see if evaporator is plugged
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
HOW TO REPLACE Blower ON 1997 PONTIAC GRAND PRIX?
Should be located at passenger's side firewall Remove wiring Remove intake air hose Remove 3-4 small bolts at flange Remove blower motor Should be located at passenger's side firewall Remove wiring Remove intake air hose Remove 3-4 small bolts at flange Remove blower motor
How can you remove and replace a blower motor on a 1992 Lincoln Town Car without having to remove the antifreeze reservoir?
If the reservoir is blocking the way, then it will have to be removed.
How do you install a 1997 E320 Mercedes Benz blower motor?
The blower motor is located above the passenger foot well inside the dashboard below the glovebox. I recently changed my blower for $230. it is not that difficult. I understand the dealer charges much more. It is accessed from the panel above the footwell. With a phillips screwdriver remove two screws holding the panel in. pull the panel down and towards the passenger seat. (you can leave the light wire attatched and lean the cover against the transmission hump. Now you will need a Torx driver to remove 5 torx screws holging the blower cover in place. Disconnect the electrical connection to the fan blower where it meets the blower box. Use the same torx drive to remove the 4 torx screws holding the blower in place. For pictures of this disassembly look at the website in the related links.
Where is the blower motor resistor on a 1993 ford ranger?
My Haynes manual shows it under the passenger's side dashboard, near the firewall. It looks like there's a bundle of wires running to it from the switch and the blower motor itself.
How do you replace a door handle on a Ford Fiesta?
You will need to remove the inside door panel of your Mustang. Remove the linkage from the outside door handle. Remove the outside door handle retaining bolts. Reverse the process to install the new outside door handle.
How do you change brake light bulb in 1996 ford crown vic?
Trunk open, remove the 4 wing nuts on the casing. The casing will pull off from the outside. The bulbs are in there.
Where is the blower resistor on a 92 Honda accord lx?
The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it. The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it.
How do you change tail light bulb on 1996 ford crown Victoria?
open trunk, remove the 4 wing nuts, remove the casing from the outside. Bulbs are in there.
How do you change blower fan on 1992 Buick Roadmaster?
The blower is just under the passenger side dash. There are three 9/32" bolts that hold the casing up. Remove those and unplug the blower. Then the blower should be able to fall right out. May need to "jimmy" it a bit to get it out. When you get the new blower, plug it in and turn on the air before you install it, that way you can make sure that it will work.
How do you change blower motor on 2001 corvette?
Remove the wiring harness from the back of your 2001 Chevrolet Corvette blower motor. Remove the blower motor retaining bolts. Remove the blower motor fan. Reverse the process to install the new blower motor.
How do you change rear brake light bulb on 1994 crown vic?
Should be the same as the '96. From inside the trunk there are 3 maybe 4 wing nuts on the inside of the light casing. Remove them and the whole light casing comes off from the outside. There are the bulbs.
How to change blower motor on 1996 Chevy Corsica?
Remove the wiring harness from the back of your 1996 Chevy Corsica blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install the new blower motor.
How do you change a blower motor on a 1995 cutlass supreme?
Remove the wiring harness from the back of your 1995 Oldsmobile Cutlass blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.
How do I change a blower motor on a 1994 Chevy surburban?
It is on the lower passenger side under the dash/glovebox. Remove the cover over the blower, remove 4 bolts and blower will drop out.
Where is the 2001 jeep Cherokee blower motor resistor exact location at the blower itself?
Right behind the glove box. Remove the three screws at bottom of glove box. Once it is off you will see it on the blower casing. Remove shroud from below with an 8mm socket. Same socket will remove resistor. Total work time ~10-20 minutes.
How do I change a garage door light bulb?
To change the garage door light bulb you need to remove the protective casing. Once you have removed the positive casing, you can replace it with a new one.
Where is the blower motor located on a 2001 olds aurora how do you change it?
Remove cover on firewall under the hood, then remove the cabin filter and you will see the blower.
