attached to the steering coloum , about halfway down, it has a small plastic cover over it
The 1998 Ford Escort starter motor is located on the rear of the engine. The starter motor will be on the right hand side, near the bottom of the motor.
I need to know the best way to remove and install the new window motor for a 96 Ford Windstar drivers side. Ray
It is wise to know the cost of replacing car parts before owning a car. The Ford KA starter motor should cost between $150 and $400.
According to the 2003 Ford Focus Owner Guide ( North America ) ( 5W-20 )
firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of Ford vehicle
Blown fuse, defective blower motor resistor pack, blower motor, or blower motor switch. This happened to me and I found a connector at the fan motor had fried. I changed the connector and it worked great.
Disconnect the fan motor electrical connector. Unbolt the fan bracket and shroud assembly. Take the harness connector from the shroud. Lift the shroud out of the engine compartment. To separate the fan from the motor take loose the motor shaft clip. Remove the bracket from the fan motor by detatching the harness from the retainers then remove the mounting screws.
On a 1995 Ford Econoline E350, the resistor is located to the right of the blower motor in the engine compartment. It is the second plug attached to the blower motor wiring harness. It has two screws and a white connector compared to the black one for the blower motor.
On the 5.4 the knock sensor is under the intake and the connector is in the back of the motor on the passenger side.
Henry Ford - Creator of the Ford Motor Company.Henry Ford - Creator of the Ford Motor Company.Henry Ford - Creator of the Ford Motor Company.Henry Ford - Creator of the Ford Motor Company.Henry Ford - Creator of the Ford Motor Company.Henry Ford - Creator of the Ford Motor Company.
The Ford F450 OBD connector can be found on the top of the engine. The ODB connector will be near the air intake housing.
by the blower motor there is a resistor connection, you will find it melted the blower motor is bad. it draws to much power causing the connection to get hot and melt and burn. you will have to change the connector and the blower motor. the blower is still working but its drawing to much power, the motor windings are shorted out inside. disconnect the connector from the resistor and you will see it.
you have left a small lead with a female connector off the starter motor solonoid
It could be the motor, switch, relay, corroded or dirty connector, damaged wire or blown fuse.
this resistor is located next to the blower motor in the heater plenum. the coils sit in the air stream. remove the connector and the fasteners and pull the resistor block out.
The Ford 460 CUID is a reliable motor, but you won't be passing too many gas stations.
If it's anything like my girlfriends 2007, its underneath the glovebox. It's held in place by 3 screws and a wiring connector.