answersLogoWhite

0


Best Answer

difficult creature you've got... I hope you have a manual, because if your planning on keeping it, you'll need one. Ok.. Vacuum leak Bad Timing if it's missing check all ignition components try a new fuel filter check the fuel pressure(too high or too low) good luck d

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does your 1987 Trans Am with 1989 motor 5.0 start and idle but shuts off when you attempt to accellerate?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does the anti theft shut down all electronics to motor?

no just the motor shuts down


1989 trans am it start up and runs but when you give it gas it shuts down?

May be partial blockage in fuel line.


When you turn left on occasions the motor shuts off?

well that means that your car just BLOWS


Why does the roketa 250cc motor scooter idle ruff and then shuts off?

YOU WILL HAVE TO INCREASE THE IDLE RPM.


Furnace turns on gets to temp blower motor starts thens shuts off almost immediately motor is hot to touch?

Replace blower motor it's burned up.


When you put your 1994 Chrysler Le baron in gear it shuts off and the transmission fluid is black.?

Bad torque converter, replace and rebuild trans.


How does engine immobilizer works?

It sends a signal though one of you motors kill/stop switches and shuts the motor off.


Symptoms of a bad throttle position sensor on a mercury outboard engine?

motor shuts off when put in gear sometimes


How do you trouble shoot a synchronous motor that shuts down on power factor within one minute?

Not sure why you are describing the shut down as being power factor related. If it shuts down after a short period I would expect that the motor has a thermal protection cutoff and the shut down is being caused by a bearing over heating.


While driving your 2000 deville once it heats up it shuts off and doesn't crank until it cools a little you've changed the crank sensors top and bottom what else could it be?

It may be heating up too much. There is a sensor that shuts down the motor when it gets too hot to keep from damaging the motor.


Why does the blower fan work on speeds 1 and 2 but shuts down on 3 or 4 and then does not work on any speeds?

Two possible issues The motor may be bad and the control shuts down when it is turned up to protect the control The control is bad


97 Grand Prix motor stalls out when AC is on?

The compressor may have locked up, do you hear a squeal before the engine shuts down?