0
Why would a 1990 Geo Prizm be very hard to start when the engine is cold but start fine when the engine is hot?
Wiki User
∙ 17y ago
You probably need a new set of plug wires. If the ones on it are original, they are probably breaking down and have a lot of resistance as opposed to a new set.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
1990 Cutlass Supreme 3.1 liter fuel injected died on the side of the road today engine will not start or if it does it won't stay running as soon as you give it gas it quits?
Well the engine might be flooded
What if your 1990 chrysler new yorker wont start starter works engine wont turn over?
teeth on fly wheel may be rounded or teeth on stearter drive are rounded.
What engine liter does a 300ZX have?
A 1990-1996 has a 3.0L V6
The Location of a Starter Relay on a 1990 Chrysler New Yorker?
On a 1990 Chrysler New Yorker, the starter relay is built into the starter. The starter is located on the front of the engine, behind the engine mount.
Can the voltage regulator stop the motor from firing on a 1990 dodge 250 van?
No, the voltage regulator determines the alternators output voltage. That's all it does. If the regulator fails the battery level can drop to the point that there will not be sufficient charge to start the engine, but the regulator will not directly cause the engine to not run.
Where is the ECU on a 1990 Geo Prizm?
Ther are three different engine configurations used on the 1990 prizm. Check a repair manual such as Haynes. If you plan on keeping the car for a long time a manual would be a good investment.
Can you put an engine from a 1990 Geo Prizm into a Toyota Corolla?
Yes, not a problem. Any unfit components swap it from your old engine.
What are the spark plug gap specs on a 1990 geo prizm?
.41 is the gap specified by the Haynes manual for the 1990 Geo Prizm.
Why would the battery light and the brake light both be on on a 1990 geo prizm?
because you ugly alternater.
Where is the vacuum diagram located on 1990 Geo Prizm?
where is the vacuum diagram located on 1995 geo prizm
What do codes 12 or 71 on a 1990 Geo Prizm when the check engine light is on?
1990 GEO PRIZM code 12 = RPM Signal Distributor, distributor circuit,starter signal circuit, igniter circuit igniter, ECM 1990 GEO PRIZM code 71 = EGR EGR system including hoses,gas temperature sensor circuit, gas temperature sensor, vacuum switching valve for the EGR circuit, ECM
Will a Toyota corolla transmission fit in a Geo Prizm?
what transmission will fit in a 3 speed 1990 geo prizm
Can you replace the door of a 1990 Geo Prizm with an older Toyota Corolla or any other vehicle?
yes but do check first because a 1990 Geo prizm is basically a re branded version of a 1990 Toyota corolla.
Where is the fuel pressure regulator on a 1990 geo prism?
The fuel pressure regulator on a 1990 Geo Prizm is located in the fuel line that runs along the valve cover of the engine. It is an inline device that is no bigger than the fuel line itself.
Why would a 1990 olds ninety eight run rich when cold start Service engine and temp light on No codes?
If the check engine light is on with no codes, you have a wiring or computer issue.
Where is the location of the Electronic Control Module on a 1990 Geo Prizm?
it is inside of the distributor assymbly
Where is gasoline filter on 1990 Geo Prizm?
behind the drivers side rear tire on the frame
