0
What else can I help you with?
How do you remove a front bumper cover for an odyssey 1995?
1. Remove the two bolts underneath the ends of the front bumper with a socket wrench. 2. Unfasten the six clips underneath the front bumper along the center with a screwdriver. 3. Remove the two clips on the top of the front bumper next to the radiator, using a screwdriver. 4. Unfasten the screw that secures the front bumper to each fenderwell, using a screwdriver. The fenderwells are the void areas where the front tires sit in the vehicle frame. 5. Lift the front bumper off the frame of the Honda Odyssey and set it out of the way.
How do you remove the front bumper on a 2006 civic?
1. Remove upper grill cover clips. (1 on each side by the fender, and two in the middle by the hood release)2. Remove 2 Philip screws, 1 on each side of bumper by the tire.3. Remove the bumper clips below the vehicle.4. Using an Allen key, unbolt the two bolts holding the bumper left. They are located on top of the bumper, in the middle of the front by the hood release.5. Slow pull on one end of the bumper, moving your hand closer to the middle of the front of the car. Then do the other side. Finally just take the bumper away from the vehicle CAREFULLY.*from:http://www.8thcivic.com/forums/do-yourself-articles/9167-removing-front-bumper-ex-coupe.HTML
How do you remove the bumper from the 1989 Chevrolet Celebrity?
To remove the front bumper from a Celebrity: 1. Raise the vehicle as needed and put on stands. The parking brake should be on. 2. Remove the end covers 3. Remove the valence cover. 4. Remove the nuts that hold the bumper to the mounting struts. Be careful to avoid having the bumper fall off onto you. 5. Remove the bumper. Reverse these instructions to put the bumper back on.
How do you remove the front bumber on a 92 Acura Integra?
1. Remover bumper turn signals. 2. Remove the corner makers. (they are adhered by 1 screw) 3. Remove the bumper corner brackets. They have 2 screws on each side. 4. Unscrew the 2 screws for the sliders/clips located on each side in front of the front tires. 5. Remove the 4 bolts holding the bumper on. Put something under it to help hold it so it doesn't drop. The bolts are located inside where the bumper lights go. There should be 2 12mm bolts on each side. 6. Now under the lip part of the bumper there should be 6 10mm bolts holding the dust cover on. Remove them and slowly pull the bumper off. You will need to un-clip the sides of the bumper.
How to change front bumper '92 SL2?
1. apply the parking brake, block rear wheels, jack up front end and place on jack stands2. disconect negative battery cable3.detatch air duct from bumper cover (ac models)4.remove side markers and headlamp assemblies5.remove bumper cover nuts, bolts, and clips6.disconect any electrical connectors that would interfere7.remove the rivets and retainers and pull the absorber and bumper assemblies
How do you replace the fog lights on a 1998 aurora?
Answerremove the front bumper cover and unscrew de fog light Actually you don't have to remove the front bumper at all.1) Jack the front of the car up by placing the jack on the frame of the car2) There is a plastic deflector piece that is in between the frame of the car (that the jack is on) and the front bumper that runs from passenger front wheel to driver front wheel. This is there to keep dirt and rocks out of the engine/radiator3) Remove the 5 plastic place holders by taking out the center "head" and then taking the flat part of the placeholder out. These are fragile so take your time, they will come out with some love4) Remove the plastic deflector piece and you will now be able to see the back of the fog lamp housing, allowing you to twist the lamp (counter clockwise) and remove the bulb5) DONT REMOVE THE FRONT BUMPER, unless you like wasting afternoons.
How do you remove the front fender of 1998 Audi?
1) Remove the Torx screws just in front of the front wheels attaching the front bumper to the plastic bodywork parts. 2) Flip off the outer front grills, that house the fog lamps if you have them. 3) Lie on the floor looking up, and you'll see an 6mm Allen headed Bolton the underside of the reveals. 4) Remove. 5) Carefully tug the bumper off, trying to keep it straight and square. 6) Carefully remove the electrical connections. That's it
How do i remove the front bumper on a 2004 Honda Accord?
Very easy. You will find 1 phillips screw on each side of the bumper cover. Remove those. There are 4 bolts size 10mm to remove. You will then have to remove plastic clips holding the bumper in place. 5 on the top and some more on the bottom. Yo also have to remove the grill. This video will walk you through the process. https://www.youtube.com/watch?v=sNBrRvy_-os
How do you remove front bumper from 1999 dodge Dakota slt v8 magnum?
you need a socket set with an extension 1. open the hood 2. located the 4 bolts holding on the bumper just in front of the radiator 3. remove one bolt from each side 4. have a friend hold one side of the bumper while you remove the last 2 bolts having a friend there is important cuz dak bumpers are oddly weighted and hard to carry by your self
How do you remove your front bumper off your clio 172?
remove top torx screw in arch liner, peel back liner to expose 10mm bolt (1 each side). remove lower torx screws located on bottom edge of bumper almost in line with foglamps. underneath car you will find a plastic flap attached to crossmember, you can either drill out the rivets at the front or remove the 3 10mm bolts at the rear. last but not least remove the two torx screws (1 each side) located in gap between bumper and bonnet. unplug the fog lamp connector located behind passanger side foglamp. pull bumper tips out and pull bumper forward and free from the vehicle. (based on 2001 clio 172 UK model)
Will a 1999 Dodge Ram sport bumper fit a 1998 Dodge Ram 1500?
Yes NO they have 2 types of sport packages--multi pc. STEEL front bumper and a 1 pc. PLASTIC front bumper--the grill fot this bumper is larger and will not fit the steel bumper.
Can you fit a Land rover Discovery Series 2 front bumper onto a Land rover Discovery Series 1?
Can you fit a 300tdi front bumper to a 200tdi
