I believe it is on the drivers side behind the fuse box. I am dealing with this myself. It has 3 prongs and there is a relay switch beside it. My fusible link gets hot.
The codes on a 1994 Sundance are 2 digit codes. Code 3 is not correct.
You can purchase a dipstick from the dealer.
Remove the tire and wheel from your 1994 Plymouth Sundance. Remove the brake assembly spring. The brake pads will come off. Reverse the process to install the new brakes.
Code 43 refers to the coil. Code 55 is end of message.
I just purchased a 1994 Plymouth sundance from my niegbor for dirt cheap (joe dirt) it has been sitting for about three years.just wanted to see if I could fire it up. put a new batt. in it . it cranks over but no fire I primed it with gas it fires and runs until gas burns out .I am thinking maybe a fuel pump from sitting so long! what do you think?
How do I change th starter on a 1994 Plymouth sundance
No, it is not an interference engine.
The codes on a 1994 Sundance are 2 digit codes. Code 3 is not correct.
in the fuse box
You can purchase a dipstick from the dealer.
It is screwed into the exhaust manifold on the rear of the engine.
A 1994 Plymouth Sundance/Duster does not use a speedometer cable. Instead, it uses a Speed Sensor located on the transmission.
Front camber is adjusted at the strut to knuckle bolts.
passenger side rear next to fuel tank
Remove the tire and wheel from your 1994 Plymouth Sundance. Remove the brake assembly spring. The brake pads will come off. Reverse the process to install the new brakes.
No. It Is Held In Place From The Bottom .
Electrical located in the fuel tank