Cadillac Escalade

The 2009 Cadillac Escalade's engine produces 403 hp @ 5700 rpm.

The curb weight of the 2003 Cadillac Escalade-ESV is 5869 lbs..

it is not really a chip. it is actually a resistor. you can buy one on eBay for about $5.00. look it up. i bought one, increases by 10 hp and shifts later, improving torque. tricks computer into thinking the air temp is about 60 degrees Fahrenheit.

along the frameof truck follow back from tank

people say it will b destoyed by the sun in 2014, but i don't believe them. but then again they do say scientists figured that out. oh well!i don't believe it and niether should u. it wont be. im sure of it now. because we would have been told by now.

The 2009 Cadillac Escalade has a 9 ft. 8 in. (116 in.) wheel base.

Up to 300,000 miles!

It's broke

gas and a match.........

The gas tank on the 2004 Cadillac Escalade-ESV holds 31 gal..

The height of the 2014 Cadillac Escalade-ESV is 6 ft. 3.5 in. (75.5 in.).

Usually a problem in the emission control system - have vehicle scanned to determine the problem

The maximum tosing capacity of the 2011 Cadillac Escalade is 8100 lbs..

The 2003 Cadillac Escalade-ESV has overhead valves (OHV).

An individual could purchase a used Cadillac Escalade SUV by researching automobile dealerships, and online car selling sites. A Cadillac dealership would be the best option to try first.

The gas tank on the 2009 Cadillac Escalade-ESV holds 31.0 gal..

The color of the coolant does not necessarily mean that they have the same composition. To be on the safe side, you need to verify the composition of both coolants to ensure they are compatible.

The 2008 Cadillac Escalade-ESV has a 6.2 L base engine size.

look at it in the daylight not nite. open a tube of smarties, does it lok like any of these colors yet? if so, then your car color is this.

Turn key on, Then push gas pedal all the way to the floor 3 times

Then turn key off then start engine.

The gas tank on the 2007 Cadillac Escalade holds 26.0 gal..

Many reasons! Go to the Dealer or Auto Zone (free) and have your problem codes read from the computer in the car.

I have just change the fuel pump on my 2003.

Put your cad. on a ramp. you can jack up one wheel at a time if cad. will not run.
You will need the room to work under the cad.


Disconnect the battery,relieve the fuel system pressure, drain tank and disconnect the tank, disconnect fuel evaporative emission lines from the tank,


You can use a siphon hose to drain the tank, take off the hose connected to the back of the tank and drain from there.


There are two retaining straps holding the tank up, unscrew the bolts let the rear of the tank down. This will make it easy to remove the lines from the clip to the tank. do not disconnect the lines from the cad. or the tank, it is enough room to move the tank from under the cad. to the driver side, this will save you some work!


Remove retaining ring with hammer and screwdriver, also replace with hammer and screwdriver. You will have to hit the retaining harder to put it back on.


Pull out fuel pump note place where screen located, replace new fuel pump and rubber seal .


You must change the harness, this should be included in fuel pump kit, the instruction are in the kit.

The light bulb may be burnt out for the dashboard display. The fuse for the dashboard display may be blown. The fuse can be found in the fuse box.

Yes.

It's made by GM.

Enough said?