0
Cadillac Seville
This category covers questions about the Cadillac Seville, a mid-sized luxury sedan manufactured by General Motors and sold through its Cadillac division. The Seville was originally released as a limited production specialty model in 1956 and was discontinued in 1960. It was reintroduced in 1975 as a regular production model and continued to be sold until it was replaced by the Cadillac STS in 2004.
975 Questions
How do you install an alternator in 97 cadillac deville?
Take the battery out first(you have to do this to get to the half inch drive, belt tensioner to take the belt off), take the belt off WRITE DOWN THE ROUTING IF THERE IS NO BELT ROUTE STICKER!!!!!, take the radiator cooling fans out (two plugs,, 4 bolts, easy), under the car there is a plate on the same side as the alternator that has to be removed to allow space to put the exchanged alternators through it is maybe 8 inches long and has 4 bolts 2 vertical and two you can see on the bottom. It HAS to come through the bottom and through this hole!! The casing of the alternator is basically square looking on the backside. to get it thru the hole it HAS to be flat side of the square to the radiator side and the other to the motor side!!!to fit through, that's how tight the tolerance is. one bolt hole towards the driver side and one towards the passenger side. there are 3 bolts 2 front side and one rear side, and the electrical main connector bolt and plug on the back and side of the alternator, remove them. Note:: the rear bolt on the casing mount may not come completely out,, Dont freak, it will still allow the alternator to release. It butts up against the exhaust manifold. Install is the exact reverse of this. This is not a fun job and I can't say this loud enough GET A QUALITY ALTERNATOR!!!! DON'T BE CHEAP! OR YOU WILL BE DOING THIS JOB AGAIN REALLY SOON. And just for addition to change the a/c compressor is a nightmare, hope that works ok ..
Where is pcm located on 01 Cadillac Seville?
On a 2001 Cadillac Seville, the Powertrain Control Module (PCM) is typically located in the engine compartment. Specifically, it can be found mounted on the driver's side of the vehicle, near the firewall. To access it, you may need to remove some panels or components that obstruct the area. Always consult the vehicle's service manual for precise instructions and safety precautions.
Where is the rear shocks air compressor located on a 1998 Cadillac Seville sts?
On a 1998 Cadillac Seville STS, the rear shocks air compressor is located in the trunk, specifically on the driver's side, near the spare tire well. It is part of the vehicle's self-leveling suspension system, which uses air to adjust the ride height. Accessing it may require removing some trunk trim or carpeting for better visibility and reach.
How do you change a reverse light bulb on a 1997 Cadillac Seville?
To change the reverse light bulb on a 1997 Cadillac Seville, first, open the trunk and remove the trunk liner or access panel to reach the tail light assembly. Next, twist the bulb socket counterclockwise to remove it, then pull the old bulb straight out. Insert the new bulb into the socket, replace the socket into the assembly, and secure it by twisting it clockwise. Finally, replace the trunk liner or access panel and test the new reverse light.
How do you manually raise a power window that is stuck on a 1997 Cadillac Seville STS?
To manually raise a stuck power window on a 1997 Cadillac Seville STS, first remove the door panel to access the window motor and regulator. Locate the window motor and disconnect the power connector. You can then use a 12-volt power source to apply direct voltage to the motor terminals, which will allow you to raise the window manually. Ensure to be cautious and keep fingers clear of the window's movement as you do this.
How much is it to replace a broken blend door on a 98 Cadillac Seville sts?
Replacing a broken blend door on a 1998 Cadillac Seville STS typically costs between $500 and $1,200, depending on labor rates and parts availability. The blend door itself may cost around $50 to $150, but labor can be significant due to the complexity of accessing the component. Always consult with a trusted mechanic for a precise estimate based on your specific vehicle condition and local rates.
How do you clean the inside of 1990 cadillac sedan Seville throttle body?
To clean the throttle body of a 1990 Cadillac Sedan Seville, first, disconnect the battery and remove the air intake duct. Carefully detach the throttle body from the intake manifold by unscrewing the bolts. Use a throttle body cleaner and a soft brush or cloth to wipe away carbon buildup and grime inside the throttle body. Reassemble everything, ensuring all connections are secure, and reconnect the battery before starting the engine.
Where is the deterrent module on Cadillac Seville?
The deterrent module on a Cadillac Seville is typically located under the dashboard, near the steering column or behind the glove box. It is part of the vehicle's security system, which may include features like theft deterrent and alarm functions. For precise location, referring to the vehicle's service manual is recommended, as it provides detailed diagrams and instructions.
Where is the camshaft sensor for a 1995 cadillac deville 4.9 ltr?
The camshaft sensor on a 1995 Cadillac DeVille with a 4.9-liter engine is located at the rear of the engine, near the firewall. It is typically mounted on the cylinder head or the engine block. To access it, you may need to remove some components for better visibility and space. Always refer to a repair manual for detailed instructions specific to your vehicle.
