Chevy Camaro RS

to be honest you will get more power wit a natural asperated 350 then a blown 305 the motor just sucks for getting power no disrepect. you will spend 6000 dollars for just about 100 hp you can but a stroked 350 ready to go for 4000 bucks with over 550 hp cjeck jegd a summit racing for complete engines use the 305 for a boat anchor

594

The M-20 transmission typically requires a specific type of transmission fluid, often either a manual transmission fluid (MTF) or a specific gear oil, such as 80W-90 weight gear oil. It's important to refer to the vehicle's owner manual or manufacturer's specifications for the exact recommended fluid, as using the correct oil ensures optimal performance and longevity of the transmission.

I dont understand what you are asking. If the cam is bad the engine will still run just real bad.And running it with a bad cam could destroy the engine. Now if you mean put in a new cam,you will need new lifters and new valve springs with retainers and new valve stem seals. Also you have to "break in" a new cam, if you dont do it right it will fail within a few minutes. You need to be way more clear on what you are asking.

about 3000 dollars

is it posiable to change your 94 camaro 3.4 eng to a 85 305

eng

if it is bmx that your on about, you cannot really do it, you will have to buy a whole new rim. .

No you can not this began in 94 when the body style first changed to 4th generation.........

No, it uses speed density the 2.8 v6 camaro uses a MAF sensor.

When cranking, the ballast resistor is bypassed to give a hotter spark. If during cranking you do not have power at the coil, but when the key is turned to run you do; there is a problem with the bypass circuit (sometimes it comes from the starter motor solenoid wire)

The cost of the 4 major peanuts spiked up about 60% in August.

the ss stands for super sport and rs stands for rally sport ... z28 .... your guess is as good as mine , ss is the best in my eyes .

If it starts at all I'd say it isn't the key, check the MAF sensor.

I don"t think they ever stopped, cause there's tons of people out there restoring them or building them. im currently building a 1927 model T roadster so i would say no.

hope i helped.

Assuming you're talking about a V6 model, they had 200 hp

Rear

The 6 R's are :

Rethink, Reuse, Recycle, Repair, Reduce and Refuse.

reduce

reuse

recycle

recover

refuse

An RS-232 port was once a standard feature of a personal computer for connections to modems, printers, mice, data storage, un-interruptible power supplies, and other peripheral devices.

I'm not sure but check under the hood on the driver's side in the fuse and relay box

How do I install rear coil springs on a 1996 Camaro?

Show me you how to install window motor for 1992 Chevy camaro

There are a lot of variables when checking compression...basically the idea is to have all cylinders within 15 lbs of each other. Double check your readings.

First you attempt to remove the bolt with an 'ease out' type tool. If that fails you then must either: take the head off to have it drilled, or drill it on the car, then thread and insert a thread repair insert.